Peças

Não são necessárias peças.

  1. Before removing the battery from the laptop, make sure the power is off.
    • Before removing the battery from the laptop, make sure the power is off.

    • Push both battery locking clips outward at the same time.

    Adicionar comentário

  2. Slide the battery out of the laptop.
    • Slide the battery out of the laptop.

    Adicionar comentário

    • Remove the four 4-mm screws on the bottom of the laptop using a #0 screw driver.

    Adicionar comentário

    • Carefully turn the laptop over and open the screen all the way.

    • Locate the slot to remove the keyboard in the lower left hand corner.

    • Using a spudger as a lever, insert it into the slot and gently pry up.

    Adicionar comentário

    • After the keyboard pops up, pull it away from the screen just enough to release the tabs.

    • Don’t pull the keyboard out forcefully as there is still a ribbon attached to the laptop.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.

    Adicionar comentário

    • Remove the flexible ribbon from ZIF connector.

    • Do not pull on the ribbon to remove it from the ZIF connector.

    Adicionar comentário

    • Position the laptop so that the bottom is facing upward.

    • Remove the 3 #0 4 mm screws holding the bottom of the palm rest.

    Adicionar comentário

    • Return the laptop to proper position and open the screen.

    • Remove the 6 #0 4 mm screws holding in the palm rest.

    Adicionar comentário

    • Gently lift the palm rest and rotate it outward so that the bottom is now facing up.

    • The ribbon attached to the track is short and extremely delicate. Use care when moving the palm rest.

    Adicionar comentário

    • Lift up on the small ZIF connector and remove ribbon.

    • If ribbon seems stuck gently wiggle it to remove. Do not pull ribbon with great force.

    Adicionar comentário

    • Remove the 4 3 mm screws that hold the cooling fan to the system board.

    Adicionar comentário

    • Remove the tape holding the cooling fan wires down.

    Adicionar comentário

    • Unplug the cooling fan wires from the system board by gently pulling on the hard molded plastic portion.

    • Be careful not to damage the wires by tugging on them.

    Adicionar comentário

    • Lift the cooling fan out of the laptop.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Taylor Bateman

Member since: 20-01-2012

93 reputação

2 Guides authored

Equipe

Cal Poly, Team 11-20, Maness Winter 2012 Membro de Cal Poly, Team 11-20, Maness Winter 2012

CPSU-MANESS-W12S11G20

4 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 2

Todo: 1,201