Peças

Não são necessárias peças.

Before removing the battery from the laptop, make sure the power is off.
  • Before removing the battery from the laptop, make sure the power is off.

  • Push both battery locking clips outward at the same time.

Adicionar comentário

Slide the battery out of the laptop.
  • Slide the battery out of the laptop.

Adicionar comentário

Remove the four 4-mm screws on the bottom of the laptop using a #0 screw driver.
  • Remove the four 4-mm screws on the bottom of the laptop using a #0 screw driver.

Adicionar comentário

Carefully turn the laptop over and open the screen all the way. Locate the slot to remove the keyboard in the lower left hand corner.
  • Carefully turn the laptop over and open the screen all the way.

  • Locate the slot to remove the keyboard in the lower left hand corner.

  • Using a spudger as a lever, insert it into the slot and gently pry up.

Adicionar comentário

After the keyboard pops up, pull it away from the screen just enough to release the tabs.
  • After the keyboard pops up, pull it away from the screen just enough to release the tabs.

  • Don’t pull the keyboard out forcefully as there is still a ribbon attached to the laptop.

Adicionar comentário

Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.
  • Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.

Adicionar comentário

Remove the flexible ribbon from ZIF connector.
  • Remove the flexible ribbon from ZIF connector.

  • Do not pull on the ribbon to remove it from the ZIF connector.

Adicionar comentário

Position the laptop so that the bottom is facing upward.
  • Position the laptop so that the bottom is facing upward.

  • Remove the 3 #0 4 mm screws holding the bottom of the palm rest.

Adicionar comentário

Return the laptop to proper position and open the screen.
  • Return the laptop to proper position and open the screen.

  • Remove the 6 #0 4 mm screws holding in the palm rest.

Adicionar comentário

Gently lift the palm rest and rotate it outward so that the bottom is now facing up.
  • Gently lift the palm rest and rotate it outward so that the bottom is now facing up.

  • The ribbon attached to the track is short and extremely delicate. Use care when moving the palm rest.

Adicionar comentário

Lift up on the small ZIF connector and remove ribbon.
  • Lift up on the small ZIF connector and remove ribbon.

  • If ribbon seems stuck gently wiggle it to remove. Do not pull ribbon with great force.

Adicionar comentário

Remove the #00 4 mm screws holding the speakers in place.
  • Remove the #00 4 mm screws holding the speakers in place.

Adicionar comentário

Gently pull the speaker cable out.
  • Gently pull the speaker cable out.

  • If the wire is tight, wiggle it back and forth but don’t apply too much force.

  • Do not use the speaker wire to pull itself out of the connector.

Adicionar comentário

Pull the speakers straight up and out of the laptop.
  • Pull the speakers straight up and out of the laptop.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Elai Fresco

Member since: 20-01-2012

7 reputação

2 Guides authored

Equipe

Cal Poly, Team 11-20, Maness Winter 2012 Membro de Cal Poly, Team 11-20, Maness Winter 2012

CPSU-MANESS-W12S11G20

4 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 2

Todo: 870