Ir para o conteúdo principal

Introdução

This guide will show you how to replace the battery in a Dell Latitude E5450.

If your battery is swollen, take appropriate precautions.

    • Remove the six Philips #0 screws from the lower case.

    • These screws are all 5.6 mm long, but it's still a good idea to keep track of them and make sure they go back in their proper holes!

  1. This photo shows the location of the ten clips that hold the lower case in place. Take note of the location of the clips, and refer back to this step if your lower case gets stuck during removal.
    • This photo shows the location of the ten clips that hold the lower case in place. Take note of the location of the clips, and refer back to this step if your lower case gets stuck during removal.

    • Four clips hold the upper half of the case in place and can be released by prying around them with a spudger.

    • The other six clips along the bottom edge can not be released by prying at them. Instead, they come free by sliding the whole case upward, as shown in step 5 below.

  2. Insert the flat edge of a spudger into the small divot along the top edge of the case, just below the docking station port. Pry up to release the two central clips along the upper edge of the case.
    • Insert the flat edge of a spudger into the small divot along the top edge of the case, just below the docking station port.

    • Pry up to release the two central clips along the upper edge of the case.

  3. Use your spudger to pry up the remaining clips along the top edge. Use your spudger to pry up the remaining clips along the top edge. Use your spudger to pry up the remaining clips along the top edge.
    • Use your spudger to pry up the remaining clips along the top edge.

  4. Slide the lower case upward  and remove it. Slide the lower case upward  and remove it. Slide the lower case upward  and remove it.
    • Slide the lower case upward and remove it.

  5. When reinstalling the lower case, make sure you slide the bottom edge (the edge without the cutout) into place first before snapping the rest of the clips shut. When reinstalling the lower case, make sure you slide the bottom edge (the edge without the cutout) into place first before snapping the rest of the clips shut.
    • When reinstalling the lower case, make sure you slide the bottom edge (the edge without the cutout) into place first before snapping the rest of the clips shut.

  6. Pull up on the battery connector's pull tab to disconnect the battery. Pull up on the battery connector's pull tab to disconnect the battery.
    • Pull up on the battery connector's pull tab to disconnect the battery.

  7. Remove the three 5.6 mm Philips #0 screws from the top edge of the battery.
    • Remove the three 5.6 mm Philips #0 screws from the top edge of the battery.

  8. Remove the battery from the laptop. The battery cell extends below the bottom lip of the enclosure. Make sure you lift the battery away from the bottom edge of the laptop at an angle, as shown in the photos. The battery cell extends below the bottom lip of the enclosure. Make sure you lift the battery away from the bottom edge of the laptop at an angle, as shown in the photos.
    • Remove the battery from the laptop.

    • The battery cell extends below the bottom lip of the enclosure. Make sure you lift the battery away from the bottom edge of the laptop at an angle, as shown in the photos.

  9. When installing your new battery, slide the bottom edge in first, and make sure it lays flat before you proceed to reinsert the screws or reconnect it. When installing your new battery, slide the bottom edge in first, and make sure it lays flat before you proceed to reinsert the screws or reconnect it.
    • When installing your new battery, slide the bottom edge in first, and make sure it lays flat before you proceed to reinsert the screws or reconnect it.

Conclusão

To reassemble your device, follow these instructions in reverse order.

For optimal performance, calibrate your newly-installed battery: Charge it to 100% and keep charging it for at least 2 more hours. Then use your device until it shuts off due to low battery. Finally, charge it uninterrupted to 100%.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Check out our Dell Latitude Answers community for troubleshooting help.

Taylor Dixon

Membro desde: 26/06/2018

45.805 Reputação

92 Guias de autoria

Equipe

iFixit Membro de iFixit

Community

137 Membros

16.049 Guias de autoria

im in need of dell latitude e5450 motherboard,

nick crider - Responder

Hi I got my first battery to replace my old one and when I had unboxed it and installed it it didn't turn on so I looked at the back and saw that the back had these 4 squares with there light blue patches cover them and idk if should take them off cause they seem peelable but idk of I should peel them off

Delaney - Responder

Hi! Please contact our customer support and we will get the issue resolved!

Arthur Shi -

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 3

Últimos 7 dias: 28

Últimos 30 dias: 126

Duração total: 2,963