Conserte seus objetos Comunidade Loja

DeWalt DW920 Motor Replacement

O que você precisa

  1. DeWalt DW920 Motor Replacement, Disassembly: passo 1, imagem 1 %32

    • Using an H-5.0 bit driver remove the four T-10 Torx screws.

    Editar

  2. DeWalt DW920 Motor Replacement: passo 2, imagem 1 %32

    • Use 2 H-5.0 bit drivers to take out the main bolt and head.

    • There will be blue locktite on the tread.

    Editar

  4. DeWalt DW920 Motor Replacement: passo 3, imagem 1 %32

    • Carefully remove the two halves of the handle.

    Editar

  5. DeWalt DW920 Motor Replacement, Motor: passo 4, imagem 1 %32

    • Gently lift the motor and trigger mechanism out from the frame of the drill.

    Editar

  6. DeWalt DW920 Motor Replacement: passo 5, imagem 1 %32

    • Locate where the motor assembly is attached to the trigger mechanism and carefully detach the wires at their solder points.

    • Mark where the two cables was connected using a masking tape or similar.

    Editar

  7. DeWalt DW920 Motor Replacement: passo 6, imagem 1 %32

    • Solder the new motor assembly wires to the trigger mechanism in the same fashion that the old motor was.

    • Remember to check the markers from the step before and solder the cables on the right place.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

com 4 outros contribuidores

Stephen Rada

Membro desde: 03/11/16

433 Reputação

Autoria de 4 guias

Emblemas: 9

+6 outros emblemas

Equipe

UMass Dartmouth, Team 8-2, Botvin Spring 2016 Membro de UMass Dartmouth, Team 8-2, Botvin Spring 2016

UMASSD-BOTVIN-S16S8G2

Membros da 2

Autoria de 6 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 3

Duração total: 795