Peças

Não são necessárias peças.

  1. Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.
    • Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.

    Adicionar comentário

  2. Remove the back casing to expose the circuit board.
    • Remove the back casing to expose the circuit board.

    Adicionar comentário

    • Detach the gray antenna wires by gently pulling on the side closest to the circuit board.

    Adicionar comentário

    • Detach the speaker wire by gently pulling on the side closest to the body of the camera.

    Adicionar comentário

    • Remove the two 4.35 mm screws on the circuit board using the Philips head PH00 screw driver.

    Adicionar comentário

    • Detach the white plug by gently pulling on the black wires.

    Adicionar comentário

    • Remove the circuit board to expose the camera body.

    • At the same time, you will need to feed the wires through the circuit board and out the slot in the black plate under the circuit board.

    Adicionar comentário

    • Gently pull on the grey wire to detach the microphone from the camera body.

    Adicionar comentário

    • Detach the microphone from the circuit board by gently pulling on the grey wire.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Stanley DeLuna-Dabrowski

Member since: 21-03-2018

127 reputação

Autoria de 1 guia

Equipe

IUPUI, Team S4-G2, Baechle Spring 2018 Membro de IUPUI, Team S4-G2, Baechle Spring 2018

IUPUI-BAECHLE-S18S4G2

3 Membros

3 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 4

Todo: 53