Introdução

This guide will help you with replacing the power cord if your device is not receiving power.

The replacement will require a soldering iron.

Unplug the maker, remove the coffee pot, and flip upside down. Unplug the maker, remove the coffee pot, and flip upside down.
  • Unplug the maker, remove the coffee pot, and flip upside down.

Adicionar comentário

Remove the five 1.6mm Phillips #1 screws from the bottom panel. Remove the bottom panel.
  • Remove the five 1.6mm Phillips #1 screws from the bottom panel.

  • Remove the bottom panel.

Adicionar comentário

Push the power cord inward and away from the plastic protection plate. Push the power cord inward and away from the plastic protection plate.
  • Push the power cord inward and away from the plastic protection plate.

Adicionar comentário

Remove the two 1.4mm Phillips #0 screws from the plastic protection plate. Remove the plastic protection plate.
  • Remove the two 1.4mm Phillips #0 screws from the plastic protection plate.

  • Remove the plastic protection plate.

Adicionar comentário

Remove the two 1.6mm Phillips #1 screws from the heating element. Using a flathead screwdriver to remove the outer clips holding the heating unit in place. Flip the heating element up to allow access to the circuit board.
  • Remove the two 1.6mm Phillips #1 screws from the heating element.

  • Using a flathead screwdriver to remove the outer clips holding the heating unit in place.

  • Flip the heating element up to allow access to the circuit board.

Adicionar comentário

Pull out the circuit board and rest it on the side of the machine. Desolder the power cable from the motherboard.
  • Pull out the circuit board and rest it on the side of the machine.

  • Desolder the power cable from the motherboard.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Nicholas Eales

Member since: 25-01-2018

233 reputação

Autoria de 1 guia

Equipe

USF Tampa, Team S20-G4, Passmore Spring 2018 Membro de USF Tampa, Team S20-G4, Passmore Spring 2018

USFT-PASSMORE-S18S20G4

4 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 7

Todo: 17