1. The parts depicted are the attachment pieces you should have (in addition to the conduit)
    • The parts depicted are the attachment pieces you should have (in addition to the conduit)

    Adicionar comentário

  2. Pull the cover over the conduit and the wires
    • Pull the cover over the conduit and the wires

    Adicionar comentário

    • Pull the outer yellow seal over the wires and the conduit

    • The end with the ridge should be pulled down first (i.e. that end will be closer to the cover)

    Adicionar comentário

    • Pull this piece over the wires and then screw it into the conduit

    Adicionar comentário

    • Put the connector piece into the node (may have to hold it in place for the subsequent steps)

    Adicionar comentário

    • Pull the yellow seal over the inside of the connector piece

    Adicionar comentário

    • Screw the tightener piece onto the connector

    Adicionar comentário

    • Pull the wires through the connector piece and then screw the conduit onto the connector

    Adicionar comentário

    • This is how it should look after everything is connected

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Nicholas Jeng

Member since: 16-01-2018

529 reputação

3 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 13