Ir para o conteúdo principal

Introdução

This is a prerequisite-only guide! This guide is part of another procedure and is not meant to be used alone.

Peças

Nenhum componente especificado.

  1. Case Opening Procedure, Flip over the PS4: passo 1, imagem 1 %32
    • Flip the PS4 upside-down with the back side facing towards you.

  2. Case Opening Procedure, Remove the warranty stickers: passo 2, imagem 1 %32 Case Opening Procedure, Remove the warranty stickers: passo 2, imagem 2 %32 Case Opening Procedure, Remove the warranty stickers: passo 2, imagem 3 %32
    • Use tweezers to remove the two stickers in the center of the back of the PS4 exposing two case screws.

  3. Case Opening Procedure, Remove the plastic screw covers: passo 3, imagem 1 %32 Case Opening Procedure, Remove the plastic screw covers: passo 3, imagem 2 %32
    • Use tweezers to carefully remove the plastic screw covers in each corner, exposing two more case screws.

  4. Case Opening Procedure, Remove the rear case screws: passo 4, imagem 1 %32 Case Opening Procedure, Remove the rear case screws: passo 4, imagem 2 %32
    • Remove the four 7.2 mm Torx security screws on the back of the PS4.

  5. Case Opening Procedure, Remove the lower case: passo 5, imagem 1 %32 Case Opening Procedure, Remove the lower case: passo 5, imagem 2 %32
    • Use your thumbs to lift the lower case up and off the PS4.

    • The lower case is held into place by plastic clips. You may need to use significant force to release the lower case.

  6. Case Opening Procedure: passo 6, imagem 1 %32 Case Opening Procedure: passo 6, imagem 2 %32
    • Use a pair of tweezers to pull the power supply cable straight out and disconnect the power supply unit from the motherboard.

    • If your connector feels stuck, use a spudger to gently pry the connector out.

Conclusão

To reassemble your device, follow the above steps in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Check out our Answers community for troubleshooting help.

Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

Sam Omiotek

Membro desde: 25/02/2019

47.579 Reputação

264 Guias de autoria

Equipe

iFixit Membro de iFixit

Community

145 Membros

15.517 Guias de autoria

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 1

Últimos 30 dias: 12

Duração total: 272