Canon Selphy CP910 Buttons Replacement

Introdução

The Canon Selphy CP910 is used to print pictures from a camera and WiFi connection. If there are any issues with the buttons on the printer, it may be necessary to remove them. For information regarding troubleshooting issues with the Canon Selphy CP910, go to Canon Selphy CP910 Troubleshooting.

Contact the manufacturer for inquiries about receiving parts of the Canon Selphy CP910.

O que você precisa

Passo 1 Disassembling Canon Selphy CP910 Body

Canon Selphy CP910 Buttons Replacement, Disassembling Canon Selphy CP910 Body: passo 1, imagem 1 %32

Canon Selphy CP910 Buttons Replacement, Disassembling Canon Selphy CP910 Body: passo 1, imagem 2 %32

Turn the printer over.
Use the PH1 screw bit to remove the three 8 mm screws in the middle of the back plate.
Keep track of these screws because you will need them to reassemble the printer.

Editar

Passo 2

Canon Selphy CP910 Buttons Replacement: passo 2, imagem 3 %32

Loosen up the four 10 mm corner screws.
A screwdriver with a long shaft approximately 7mm in diameter will make it easier to reach these screws.

Editar

Passo 3

Canon Selphy CP910 Buttons Replacement: passo 3, imagem 3 %32

Turn the device around and remove the "open" lid.
This lid needs to be removed in order to take the printer apart.
Gently bend the lid and remove it from its hinges.

Editar

Passo 4

Canon Selphy CP910 Buttons Replacement: passo 4, imagem 3 %32

Turn the device back over and lift the top panel up.
Disconnect the ribbon cables leading to the LCD screen.
Pull the top panel off.

Editar

Passo 5 Buttons

Canon Selphy CP910 Buttons Replacement, Buttons: passo 5, imagem 1 %32

Canon Selphy CP910 Buttons Replacement, Buttons: passo 5, imagem 2 %32

Turn the top panel over so the inside faces toward you.

Editar

Passo 6

Canon Selphy CP910 Buttons Replacement: passo 6, imagem 3 %32

Use the PH0 screw bit to remove the five 10 mm screws located above the circuit board.

Editar

Passo 7

Carefully remove the frame attached to the screen.

Editar

Passo 8

Canon Selphy CP910 Buttons Replacement: passo 8, imagem 3 %32

Take out the circuit board.
Once you take out the circuit board, you should be left with just the case.

Editar

Passo 9

There is a clear plastic “L” shaped piece that acts as the power light for the printer. The piece is not attached to the printer so take care not to lose it.
Remove the button framework and replace it with new one.

Editar