Introdução

The motherboard controls the operations of the camera. Damage to the motherboard requires an entirely new motherboard.

Peças

Não são necessárias peças.

Slide grey latch to open the battery compartment.
  • Slide grey latch to open the battery compartment.

Adicionar comentário

Push orange retaining clip to the right to free battery.
  • Push orange retaining clip to the right to free battery.

Adicionar comentário

  • Remove battery from the camera.

Adicionar comentário

  • Remove the lanyard.

Adicionar comentário

  • Remove the two 2.3mm screws (underneath the name plate) and two 2.8mm screws (next to the threaded tripod mount) from the bottom face of the camera.

  • Be careful to keep track of the different screw sizes as you proceed with this guide.

Adicionar comentário

  • Remove the single 3.8mm screw from the back face of the camera.

Adicionar comentário

  • Remove the two 2.3mm screws from the right face of the camera.

Adicionar comentário

  • Remove the two 3.2mm screws (outside edge) and two 3.7mm screws (towards middle) from the left side of the camera body.

Adicionar comentário

  • Pull the back face panel away from the front end of the body. This may take some wiggling and force.

Adicionar comentário

  • Remove the CF card door from the left side of the camera body.

Adicionar comentário

  • Remove the rubber digital a/v out cap by sliding it out of the groove on the front plate.

Adicionar comentário

  • Remove the front face by sliding it off.

Adicionar comentário

  • Remove the rubber seal that goes over the right side of the viewfinder.

Adicionar comentário

  • Remove the two 3.9mm screws that retain the laminated cooper sheet.

Adicionar comentário

  • Remove the seven wire connections that connect to the motherboard.

Adicionar comentário

  • Remove the single 3.8mm screw that is on the motherboard.

Adicionar comentário

  • Carefully remove the motherboard from the main frame of the camera body.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Orlando Zuniga

Member since: 14-04-2011

11 reputação

Autoria de 1 guia

Equipe

Cal Poly, Team 20-70, Walters Spring 2011 Membro de Cal Poly, Team 20-70, Walters Spring 2011

CPSU-WALTERS-S11S20G70

5 Membros

4 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 6

Últimos 30 dias: 6

Todo: 1,611