Ir para o conteúdo principal

Canon PowerShot SD700 Backlight Replacement

O que você precisa

  1. Canon PowerShot SD700 Backlight Replacement, Outside Case: passo 1, imagem 1 %32
    • Turn off the camera by pressing the power button above the LCD screen.

  2. Canon PowerShot SD700 Backlight Replacement: passo 2, imagem 1 %32
    • Remove the two, small screws on the bottom of the camera using a Phillip's #00 screwdriver.

  3. Canon PowerShot SD700 Backlight Replacement: passo 3, imagem 1 %32
    • Use a Phillips #00 screwdriver to remove the two, small screws on the right side of the camera.

  4. Canon PowerShot SD700 Backlight Replacement: passo 4, imagem 1 %32
    • Use a Phillips #00 screwdriver to remove the screw on the left of the camera under the A/V out Digital label.

  5. Canon PowerShot SD700 Backlight Replacement: passo 5, imagem 1 %32
    • Use a Phillips #00 screwdriver, remove the screw on the bottom of the camera near the battery and memory card slots.

    • This screw will be longer than the rest of the screws.

  6. Canon PowerShot SD700 Backlight Replacement: passo 6, imagem 1 %32
    • Remove the front, back, and side casings from the camera and set to the side.

  7. Canon PowerShot SD700 Backlight Replacement, LCD screen: passo 7, imagem 1 %32
    • Remove the two screws that connect the LCD and backlight to the main body of the camera.

  8. Canon PowerShot SD700 Backlight Replacement: passo 8, imagem 1 %32 Canon PowerShot SD700 Backlight Replacement: passo 8, imagem 2 %32 Canon PowerShot SD700 Backlight Replacement: passo 8, imagem 3 %32
    • Gently pry the LCD and the backlight from the main body of the camera.

    • Gently pry the LCD from the backlight.

    • The thin ribbon cable is for the backlight.

    • The thick ribbon cable is for the LCD screen.

  9. Canon PowerShot SD700 Backlight Replacement: passo 9, imagem 1 %32
    • Carefully lift the ZIF connector that covers the thick ribbon cable.

    • This ZIF connector is fragile. Use caution when lifting it from its down position.

    • Insert the new LCD and reassemble the camera.

  10. Canon PowerShot SD700 Backlight Replacement, Backlight: passo 10, imagem 1 %32
    • Unplug the ribbon from the housing on the circuitry.

    • Take the new ribbon and insert it into the housing.

    • Tweezers or a tool with a sharp point can be used.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Emilio Rossi

Membro desde: 04/07/11

113 Reputação

Autoria de 3 guias

Equipe

Cal Poly, Team 9-71, Walters Spring 2011 Membro de Cal Poly, Team 9-71, Walters Spring 2011

CPSU-WALTERS-S11S9G71

Membros da 4

Autoria de 9 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 4

Duração total: 1,606