Conserte seus objetos Comunidade Loja

Este guia tem alterações mais recentes. Mudar para a última versão não verificada.

Canon PowerShot S410 Back Cover Replacement

Introdução

This guide demonstrates how to remove the cameras back panel for cleaning or replacement.

O que você precisa

  1. Canon PowerShot S410 Back Cover Replacement, Battery: passo 1, imagem 1 %32 Canon PowerShot S410 Back Cover Replacement, Battery: passo 1, imagem 2 %32

    • Turn the camera with the bottom side facing up.

    • Locate the panel labeled "Batt. Open"

    • Place your finger on the panel and slide it in the direction of the arrow.

    • The slot will swing open revealing the battery pack.

    Editar

  2. Canon PowerShot S410 Back Cover Replacement: passo 2, imagem 1 %32

    • Pull the orange lever and the battery will spring out slightly.

    Editar

  3. Canon PowerShot S410 Back Cover Replacement: passo 3, imagem 1 %32

    • Grasp the battery and fully pull it out of its slot.

    • When placing the new battery back in the slot, the arrow on the battery must align with the arrow on the camera.

    Editar

  5. Canon PowerShot S410 Back Cover Replacement, Back Cover: passo 4, imagem 1 %32

    • Start by laying the camera flat with the LCD screen facing up.

    • Remove the 3.8mm screw in the upper right corner.

    Editar

  6. Canon PowerShot S410 Back Cover Replacement: passo 5, imagem 1 %32

    • Position the camera with the bottom facing up.

    • Remove the 4.8mm screw.

    • Remove the two 2.3mm screws.

    Editar

  7. Canon PowerShot S410 Back Cover Replacement: passo 6, imagem 1 %32 Canon PowerShot S410 Back Cover Replacement: passo 6, imagem 2 %32

    • Position the camera so that the rubber "AV Out Digital" tab is facing upward.

    • Slide this rubber tab out of the way to reveal the bottom screw.

    • Remove the two 3.7mm screws.

    Editar

  8. Canon PowerShot S410 Back Cover Replacement: passo 7, imagem 1 %32

    • Turn the camera with the back side facing you.

    • Grip the edges of the back plate, and carefully slide it off.

    • If there is any resistance in movement, double check there are no screws left in the chassis.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

com 8 outros contribuidores

Randy Lormand

Membro desde: 01/23/11

349 Reputação

Autoria de 3 guias

Emblemas: 8

+5 outros emblemas

Equipe

Cal Poly, Team 11-27, Maness Winter 2011 Membro de Cal Poly, Team 11-27, Maness Winter 2011

CPSU-MANESS-W11S11G27

Membros da 4

Autoria de 7 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 4

Duração total: 1,096