Introdução

This step-by-step guide demonstrates how to remove the back cover of this camera.

It's important to note where each screw is removed. If installed incorrectly, it may damage the camera.

TIPS:

  • Use an ice cube tray or egg carton, place each screw in its own cup.
  • Make notes on a piece of paper.

You will need a tiny Phillips screwdriver (#00).

Peças

Não são necessárias peças.

  1. Remove the three Phillips screws (shown) located at the bottom of the camera.
    • Remove the three Phillips screws (shown) located at the bottom of the camera.

    Adicionar comentário

  2. Open the door to the CompactFlash memory card slot by sliding it towards you and swinging it open.
    • Open the door to the CompactFlash memory card slot by sliding it towards you and swinging it open.

    • Remove the memory card if it is still in the camera.

    • Use the Phillips screwdriver to remove the Phillips screw (shown) underneath the memory card slot door.

    Adicionar comentário

    • Remove the Phillips screw (shown) located inside the top of the memory card compartment.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Open the battery compartment door at the bottom of the camera by sliding the latch to the right and then sliding the door down.

    • Remove the batteries from the compartment.

    • Unscrew the three Phillips screws (shown) located inside the battery compartment.

    • The screw on the left is longer than the other two.

    Adicionar comentário

    • You should now able to remove the top lid of the camera.

      • Be cautious of the fragile mylar cable that connects the lid to the main body of the camera.

      • Removing the lid takes a little force. Do this gently. There may be a snapping sound.

    • The door to the memory card compartment will be freed and should be removable now.

    • In other versions of this camera, there is a tab that secures the top from the wrist strap. If yours has this, you won't be able to completely separate the top until you have removed the top screw in Step 8.

    The upper screw from Step 6 must be removed first, ( also fixing top lid )

    micsch4 - Responder

    • Remove the lower Phillips screw (shown) from the side of the camera.

    • Open the small rubber door below this screw that covers the connectors.

    Adicionar comentário

    • Open and pivot the LCD screen to its widest open position.

    • Remove the rear cover by pulling it straight away from the body of the camera.

    • When reassembling the camera, remember to replace the screws in the same location from which you removed them. Otherwise, you may damage the camera.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

konrad

Member since: 11-01-2011

214 reputação

3 Guides authored

Equipe

Cal Poly, Team 7-31, Regan Winter 2011 Membro de Cal Poly, Team 7-31, Regan Winter 2011

CPSU-REGAN-W11S7G31

6 Membros

6 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 9

Todo: 4,891