Introdução

Use this guide to replace the Canon Powershot A75's speaker unit.

Peças

Não são necessárias peças.

Turn the camera over and locate the "BATT OPEN" sliding switch.
  • Turn the camera over and locate the "BATT OPEN" sliding switch.

Adicionar comentário

Slide the switch to the right.
  • Slide the switch to the right.

    • The battery cover should slide down and spring open.

Adicionar comentário

  • Remove the 4 AA batteries.

    • Watch for the orientation of the batteries as they slide out.

    • The battery orientation is shown under the battery flap itself and on a sticker next to the battery flap.

Adicionar comentário

  • Open the memory card slot by sliding it laterally until you hear a click

  • Remove the 5.9mm screw in the upper corner of the memory card slot

Adicionar comentário

  • Remove the two 4.1mm screws at the bottom of the battery flap.

Adicionar comentário

  • Lift the shutter button and speaker part from the top of the camera.

    • Do not pull the part too hard because there is a plug connecting the speaker to the camera.

Adicionar comentário

  • Using a pair of tweezers, grab the plug that connects the speaker to the camera and gently pull it out.

Adicionar comentário

  • Do not proceed to the next step unless you have previous soldering experience because you can damage the flash unit if you are not careful.

  • Remove the glue and unsolder the speaker from the outer casing. Replace or repair the speaker as necessary.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Austin Fox

Member since: 11-04-2012

1 reputação

2 Guides authored

Equipe

Cal Poly, Team 17-30, Amido Spring 2012 Membro de Cal Poly, Team 17-30, Amido Spring 2012

CPSU-AMIDO-S12S17G30

5 Membros

6 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Todo: 269