Introdução

Taking off the top of the camera allows repair access to the eye piece and command dial.

Peças

Não são necessárias peças.

  1. Open up the battery door.
    • Open up the battery door.

    Adicionar comentário

  2. Remove the batteries from the camera by sliding them out into your palm.
    • Remove the batteries from the camera by sliding them out into your palm.

    Adicionar comentário

    • Release the side latch to open the back panel.

    Adicionar comentário

    • Remove the two black 4.5mm screws above and below the latch.

    Adicionar comentário

    • Using your finger, carefully pry open the side panel from the top of camera.

    • Pull panel downwards to remove.

    • Make sure to keep track of the small black piece of rubber under the latch.

    Adicionar comentário

    • Remove the two silver 6mm Phillips #1 screws.

    Adicionar comentário

    • Flip camera over to the bottom.

    • Remove the one 5mm Phillips #1 silver screw.

    Adicionar comentário

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • Remove the front panel by pulling away from the side with the lever.

    Adicionar comentário

    • Remove three black 7.3mm Phillips #1 screws located on the corners of the camera.

    • Remove five black 4.8mm Phillips #1 screws.

    Adicionar comentário

    • Simply remove the bottom panel by prying it off with your finger.

    • When removing the panel, be sure the bottom of the camera is facing upright. There are loose gears that may fall out.

    • Be wary of a loose piece of foam attached to the bottom panel.

    Adicionar comentário

    • Remove the remote control socket cover.

    Adicionar comentário

    • Remove two black 4.5mm Phillips #1 screws.

    Adicionar comentário

    • Remove two black 4.8mm Phillips #1 screws on the front of the camera.

    Adicionar comentário

    • Pry open the side grip using a spudger.

    Adicionar comentário

    • With your hands, remove the rubber grip from the eye piece.

    Adicionar comentário

    • Remove the eyecup from the eyepiece by pushing the eyecup up.

    Adicionar comentário

    • Remove two silver 5.0mm Phillips #1 screws.

    Adicionar comentário

    • Remove the silver 5.5mm Phillips #1 screw.

    Adicionar comentário

    • Pry the top silver part of the camera off.

    • Buttons may slip out of the camera's top as the top is pulled off the camera (shown in picture two).

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Tammy Kong

Member since: 23-01-2014

643 reputação

6 Guides authored

Equipe

Cal Poly, Team 6-20, Maness Winter 2014 Membro de Cal Poly, Team 6-20, Maness Winter 2014

CPSU-MANESS-W14S6G20

4 Membros

11 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 9

Todo: 298