Introdução

Removing the side with the grip allows for replacements on the battery door, as well as access to the top panel.

Peças

Não são necessárias peças.

  1. Open up the battery door.
    • Open up the battery door.

    Adicionar comentário

  2. Remove the batteries from the camera by sliding them out into your palm.
    • Remove the batteries from the camera by sliding them out into your palm.

    Adicionar comentário

    • Release the side latch to open the back panel.

    Adicionar comentário

    • Remove the two black 4.5mm screws above and below the latch.

    Adicionar comentário

    • Using your finger, carefully pry open the side panel from the top of camera.

    • Pull panel downwards to remove.

    • Make sure to keep track of the small black piece of rubber under the latch.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the two silver 6mm Phillips #1 screws.

    Adicionar comentário

    • Flip camera over to the bottom.

    • Remove the one 5mm Phillips #1 silver screw.

    Adicionar comentário

    • Remove the front panel by pulling away from the side with the lever.

    Adicionar comentário

    • Remove three black 7.3mm Phillips #1 screws located on the corners of the camera.

    • Remove five black 4.8mm Phillips #1 screws.

    Adicionar comentário

    • Simply remove the bottom panel by prying it off with your finger.

    • When removing the panel, be sure the bottom of the camera is facing upright. There are loose gears that may fall out.

    • Be wary of a loose piece of foam attached to the bottom panel.

    Adicionar comentário

    • Remove the remote control socket cover.

    Adicionar comentário

    • Remove two black 4.5mm Phillips #1 screws.

    Adicionar comentário

    • Remove two black 4.8mm Phillips #1 screws on the front of the camera.

    Adicionar comentário

    • Pry open the side grip using a spudger.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Jordan Tang

Member since: 24-01-2014

531 reputação

5 Guides authored

Equipe

Cal Poly, Team 6-20, Maness Winter 2014 Membro de Cal Poly, Team 6-20, Maness Winter 2014

CPSU-MANESS-W14S6G20

4 Membros

11 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 5

Últimos 30 dias: 17

Todo: 427