Canary CAN100USBK Audio and USB PCB Board Replacement

Introdução

The audio jack is not used for audio, but for streaming setup data from your phone to the Canary, so it is very important to replace if damaged.

Once you remove the bottom casing and Ethernet PCB board, the audio and USB PCB board becomes accessible. Remember to pull on the power connector itself and not the wires to avoid damage.

If either the audio jack or USB type C connector are damaged, this guide will show you how to replace the board.

A Phillips #0 screwdriver can be used for both screws.

O que você precisa

Passo 1 Bottom Casing

Canary CAN100USBK Audio and USB PCB Board Replacement, Bottom Casing: passo 1, imagem 1 %32

Canary CAN100USBK Audio and USB PCB Board Replacement, Bottom Casing: passo 1, imagem 2 %32

Grip the rubber ring with your fingers and pull up.
Rotate the Canary as you pull out one tab at a time.

Editar

Passo 2

Use your Phillips #0 screwdriver to remove the four 6mm screws.

Editar

Passo 3

Canary CAN100USBK Audio and USB PCB Board Replacement: passo 3, imagem 3 %32

Use the flat end of the spudger to carefully pry off the bottom casing.
Alternate pushing up on the left and right sides until the clips holding the case in are visible.

Editar

Passo 4

Do not yank the bottom off or you may damage the ribbon cable or the ZIF connector.
Carefully remove the bottom casing by gripping it on both sides and pulling straight up.

Editar

Passo 5

Use the pointed end of the spudger to flip up the small retaining flap on the ZIF (zero insertion force) connector.
Pull the ribbon cable out towards the device.

Editar

Passo 6 Ethernet PCB Board

Canary CAN100USBK Audio and USB PCB Board Replacement, Ethernet PCB Board: passo 6, imagem 1 %32

Use your Phillips #0 screwdriver to remove the three 5mm screws.

Editar

Passo 7

Place the flat end of the spudger underneath the Ethernet PCB board and slowly pry up until it's loose.

Editar

Passo 8

Carefully pull the Ethernet PCB board away from the board that sits underneath.

Editar

Passo 9 Audio and USB PCB Board

Canary CAN100USBK Audio and USB PCB Board Replacement, Audio and USB PCB Board: passo 9, imagem 1 %32

Using your fingernails, wiggle the power connector back and forth until it becomes loose.
Pull the power connector straight out of the socket.
Pull only on the power connector and not the wires themselves to prevent damage.