1. Carefully remove the top plastic cover. It is held in place by adhesive.
    • Carefully remove the top plastic cover. It is held in place by adhesive.

    Adicionar comentário

  2. Remove the two Philipps #0 screws that hold in place the top of the phone frame and slide it off.
    • Remove the two Philipps #0 screws that hold in place the top of the phone frame and slide it off.

    Adicionar comentário

    • Remove the back cover. It mostly just clips off, but has some adhesive in the lower area.

    Adicionar comentário

    • Remove the two Philipps #0 screws securing the battery connector and unplug the later.

    Adicionar comentário

    • Remove the 6 Philipps #0 screws securing the lower cover and remove it.

    • Remove the three Philipps #0 screws holding down the bar that secures the two main lego-style plugs and remove it.

    Adicionar comentário

    • Remove the three Philipps #0 screws securing the upper cover and remove it.

    Adicionar comentário

    • Unplug the remaining ribbon cables

    • Remove the last three Philipps #0 screws securing the Motherbard.

    • Now you should be able to replace most components.

    • The screen is held in place from the front by adhesive (or not, in the earlier versions), its cable slides trough the phone to the PCB - It's the large connector in the middle.

    • The battery is glued to the frame firmly. There are three pultabs located underneath the motherboard.

    • Don't forget to remove the sim-try if you're removing the motherboard.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

raven

Member since: 02-09-2015

272 reputação

2 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 2

Últimos 7 dias: 28

Últimos 30 dias: 262

Todo: 587