Ir para o conteúdo principal

Introdução

Use this guide to remove or replace the handle casing of your Black and Decker LI2000.

Peças

Nenhum componente especificado.

  1. Remove the following five screws Three 20 mm Phillips #1 screws One 10 mm #000 Phillips screw
    • Remove the following five screws

    • Three 20 mm Phillips #1 screws

    • One 10 mm #000 Phillips screw

    • One 13 mm Phillips 31 screw

    • When you remove the 13 mm screw, the spring may pop out of the screwdriver. Point the backside of the screwdriver away from your face and others.

  2. Remove the black sticker with recycling information.
    • Remove the black sticker with recycling information.

  3. Use your fingers or a plastic opening tool to pry the casing apart.
    • Use your fingers or a plastic opening tool to pry the casing apart.

  4. Remove the plastic slider by picking it up off the screwdriver.
    • Remove the plastic slider by picking it up off the screwdriver.

    • You may consider leaving half of the casing on the screwdriver to make handling the screwdriver easier.

  5. Remove the four 15mm Phillips #1 screws. Remove the four 15mm Phillips #1 screws.
    • Remove the four 15mm Phillips #1 screws.

  6. Use a plastic opening tool to pry the casing apart. Use a plastic opening tool to pry the casing apart.
    • Use a plastic opening tool to pry the casing apart.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Katherine Simmons

Membro desde: 08/02/2016

711 Reputação

5 Guias de autoria

Equipe

IUPUI, Team 1-3, Baechle Spring 2016 Membro de IUPUI, Team 1-3, Baechle Spring 2016

IUPUI-BAECHLE-S16S1G3

4 Membros

10 Guias de autoria

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 2

Duração total: 169