Pular para o conteúdo principal

Introdução

This guide demonstrates how to replace the LED screen. There are ZIF connectors and a face place.

Peças

Nenhum componente especificado.

  1. Remove 9 screws from bottom of notebook using PH00 bit + 1 under hard drive bay. Remove 3 screws from bottom of notebook using PH00 bit. 1 is same screw spec as the other 9, and 2 are shorter.
    • Remove 9 screws from bottom of notebook using PH00 bit + 1 under hard drive bay.

    • Remove 3 screws from bottom of notebook using PH00 bit. 1 is same screw spec as the other 9, and 2 are shorter.

  2. Using the black spudger, insert its flat end between the crevice where the color changes from grey to black. The keyboard is very tightly secured.
    • Using the black spudger, insert its flat end between the crevice where the color changes from grey to black.

    • The keyboard is very tightly secured.

    • Carefully ease the spudger's end along the crevice, going around the entire frame.

    • The back connectors are short, so be careful when lifting.

  3. Lift the keyboard from the front where it is closest to the screen. Disconnect the large and small ZIF connectors attached to the motherboard by flipping the light-colored part of the switch.
    • Lift the keyboard from the front where it is closest to the screen.

    • Disconnect the large and small ZIF connectors attached to the motherboard by flipping the light-colored part of the switch.

  4. iPhone X Fix Kits

    Warranty up? No worries, we’ve got the fix.

    Comprar agora

    iPhone X Fix Kits

    Warranty up? No worries, we’ve got the fix.

    Comprar agora
  5. Remove the third and last ZIF connector on the motherboard by flipping up the dark-colored part of the switch. Now, the component should come completely free.
    • Remove the third and last ZIF connector on the motherboard by flipping up the dark-colored part of the switch.

    • Now, the component should come completely free.

  6. Unscrew the two 4mm phillips head #00 screws.
    • Unscrew the two 4mm phillips head #00 screws.

  7. Use the black spudger to pry the face plate off. The face plate is attached with adhesive. Gently peel the face plate from the base.
    • Use the black spudger to pry the face plate off.

    • The face plate is attached with adhesive.

    • Gently peel the face plate from the base.

  8. Unscrew the four 3mm Phillips head #00 screws holding the screen to the base. When sitting upright, the screen should fall forward from the top. When sitting upright, the screen should fall forward from the top.
    • Unscrew the four 3mm Phillips head #00 screws holding the screen to the base.

    • When sitting upright, the screen should fall forward from the top.

  9. Unease the yellow connecting tape with the spudger at the bottom of the screen. Pull the connector straight down and it will disconnect fairly easy.
    • Unease the yellow connecting tape with the spudger at the bottom of the screen.

    • Pull the connector straight down and it will disconnect fairly easy.

    • The screen should then be free to be removed.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 218