Introdução

These steps will show you how to remove the hard drive from you computer.

You will need to do that if the hard drive is in a good condition but the computer is not, replace it to a new one to increase the speed and capacity, or the hard drive has experienced a hardware failure.

  1. Unscrew the 10 screws around the edge of the back panel. Eight of the screws are 0.0793mm T5 ,  two of them are 0.0793 JIS #0.
    • Unscrew the 10 screws around the edge of the back panel. Eight of the screws are 0.0793mm T5 , two of them are 0.0793 JIS #0.

    Adicionar comentário

  2. Use the plastic opening tool to pry the back panel off the base of the laptop.
    • Use the plastic opening tool to pry the back panel off the base of the laptop.

    Adicionar comentário

    • Unscrew the four 0.0793 mm screws.

    Adicionar comentário

    • Using the PH0 and screwdriver from the 54 Bit Driver kit.

    Adicionar comentário

    • After removing the four screws, gently push the hard drive downward as shown.

    Adicionar comentário

    • Lift the hard drive up.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 2

Últimos 7 dias: 22

Últimos 30 dias: 72

Todo: 373