Introdução

This repair will need:

A T8 Torx Screwdriver.

Peças

Não são necessárias peças.

  1. With the Generally Disassembly completed, you may proceed to floppy drive installation.
    • With the Generally Disassembly completed, you may proceed to floppy drive installation.

    Adicionar comentário

  2. Remove the plastic panel at the bottom of the display.
    • Remove the plastic panel at the bottom of the display.

    Adicionar comentário

    • Reverse the computer to access the peripheral panel in the back.

    • Remove the two T8 Torx screws on either side of the bar code panel.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Reverse the computer to have the monitor and mousepad facing you.

    • Remove the plastic panel underneath the display.

    Adicionar comentário

    • Remove the three T8 Torx screws securing the floppy drive to the frame.

    Adicionar comentário

    • Using a spudger, lift the plastic tabs on the floppy drive securing the ribbon cable to the ribbon port.

    Adicionar comentário

    • Lift the defective floppy drive from the body of the computer.

    Adicionar comentário

    • Replace the defective drive with a new drive.

    • Follow these instructions in reverse order to reassemble the device.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Kevin Peters

Member since: 19-04-2011

114 reputação

Autoria de 1 guia

Equipe

Cal Poly, Team 20-66, Walters Spring 2011 Membro de Cal Poly, Team 20-66, Walters Spring 2011

CPSU-WALTERS-S11S20G66

4 Membros

3 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 12

Todo: 2,077