Introdução

Replace a faulty antenna on the AirPort Extreme Model A1034.

Peças

Não são necessárias peças.

Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.
  • Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.

Adicionar comentário

Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.
  • Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.

Adicionar comentário

  • Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing.

Adicionar comentário

  • Unplug the black connector on the top of the metal casing by gently pulling horizontally.

Adicionar comentário

  • Remove the two 4mm phillips screws to remove antenna.

Adicionar comentário

  • The circuit board connected to the antenna is attached to the metal case with foam adhesive.

  • Gently peel or cut the foam holding the circuit board with a knife and remove it from the AirPort.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Michael Garcia

Member since: 12-10-2011

369 reputação

5 Guides authored

Equipe

Cal Poly, Team 17-15, Regan Fall 2011 Membro de Cal Poly, Team 17-15, Regan Fall 2011

CPSU-REGAN-F11S17G15

3 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 14

Todo: 4,039