Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Peças e ferramentas

Introdução

No-one likes hot air coming from broken plastic. Use this guide to replace the outer casing of your Andis Fold-N-Go Hair Dryer to keep hot air in a happy home.

Peças

Nenhum componente especificado.

  1. Remove the two Phillips #00 screws:
    • Remove the two Phillips #00 screws:

    • One Phillips 16mm screw

    • One Phillips 14 mm screw

    • All of the hair dryer's components are held together by these two screws. Parts may quickly separate after screw removal. Tape can be used to hold everything in place.

  2. Remove the top portion of the handle. The model information and warnings are engraved on the top portion. The model information and warnings are engraved on the top portion.
    • Remove the top portion of the handle.

    • The model information and warnings are engraved on the top portion.

  3. Remove the settings switch by lifting straight up. Remove the settings switch by lifting straight up.
    • Remove the settings switch by lifting straight up.

  4. Kit de ferramentas básico para eletrônica

    Kit pequeno. Grandes possibilidades.

    Shop Toolkits

    Kit de ferramentas
    básico para
    eletrônica

    Shop Toolkits
  5. Remove the internal components from the rear portion of the handle. Remove the switch Remove the circuitboard
    • Remove the internal components from the rear portion of the handle.

    • Remove the switch

    • Remove the circuitboard

    • Remove the capacitor in black plastic

    • These parts are not secured to the handle by anything, but are all connected to each other by wires. They shouldn't be difficult to remove, but remember that they will come out together.

  6. Remove the sliding black cover at the top of the handle. Remove the sliding black cover at the top of the handle. Remove the sliding black cover at the top of the handle.
    • Remove the sliding black cover at the top of the handle.

  7. Remove the lower portion of the handle by sliding the peg out of the slot at the top of the handle. Remove the lower portion of the handle by sliding the peg out of the slot at the top of the handle.
    • Remove the lower portion of the handle by sliding the peg out of the slot at the top of the handle.

  8. Separate the silver front casing from the black rear vent. Separate the silver front casing from the black rear vent.
    • Separate the silver front casing from the black rear vent.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Scott Havard

Membro desde: 27-06-2016

39.110 Reputação

33 Guias de autoria

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 5

Últimos 30 dias: 25

Duração total: 1,269