Conserte seus objetos Comunidade Loja

American Sanders EZSand Orbital Sander 07163A 2017 Interlock Assembly Replacement

Introdução

Use this guide to remove or replace the interlock assembly in a Clarke Floor Sander 07163A 2017.

O que você precisa

  1. American Sanders EZSand Orbital Sander 07163A 2017 Interlock Assembly Replacement, Separate the handle: passo 1, imagem 1 %32

    • Before you begin, make sure the sander is turned off and unplugged.

    • Use a 3/16" hex key or driver bit to remove the six 23.4 mm-long screws holding the two halves of the handle enclosure together.

    Editar

  2. American Sanders EZSand Orbital Sander 07163A 2017 Interlock Assembly Replacement: passo 2, imagem 1 %32 American Sanders EZSand Orbital Sander 07163A 2017 Interlock Assembly Replacement: passo 2, imagem 2 %32 American Sanders EZSand Orbital Sander 07163A 2017 Interlock Assembly Replacement: passo 2, imagem 3 %32

    • The rear half of the enclosure is bolted to the handle support, so the front half will be removed first.

    • Pull the front half of the enclosure straight away from the rear half to separate the enclosure.

    • If the interlock assembly comes out with the front half of the enclosure, detach it and place it back into the rear half.

    • Remove the front half of the handle enclosure.

    Editar

  4. American Sanders EZSand Orbital Sander 07163A 2017 Interlock Assembly Replacement, Unplug the interlock assembly: passo 3, imagem 1 %32 American Sanders EZSand Orbital Sander 07163A 2017 Interlock Assembly Replacement, Unplug the interlock assembly: passo 3, imagem 2 %32 American Sanders EZSand Orbital Sander 07163A 2017 Interlock Assembly Replacement, Unplug the interlock assembly: passo 3, imagem 3 %32

    • Pull the wires connected to the interlock assembly straight out of their connectors.

    • Keep track of where each wire connects on the interlock assembly.

    Editar

  5. American Sanders EZSand Orbital Sander 07163A 2017 Interlock Assembly Replacement, Remove the interlock assembly: passo 4, imagem 1 %32

    • After all wires are disconnected from the interlock assembly, remove the interlock assembly from the handle.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Autor(a)

com 2 outros contribuidores

Adam O'Camb

Membro desde: 04/11/15

196.767 Reputação

Autoria de 416 guias

Emblemas: 39

+36 outros emblemas

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 6

Últimos 30 dias: 10

Duração total: 445