Introdução

The alarm unit is located behind the glove box. Once the glovebox is out of the way, you can remove the black plastic alarm unit, open it and change the dip switch for a less sensitive setting.

Peças

Não são necessárias peças.

Adicionar comentário

Once the glove box is out of the way, it's easy to spot the alarm unit. The green connector will be plugged into it. I had already unplugged it when I took this picture.
  • Once the glove box is out of the way, it's easy to spot the alarm unit. The green connector will be plugged into it. I had already unplugged it when I took this picture.

Adicionar comentário

It may be stubborn to get out because it is stuck down with double stick foam pads.
  • It may be stubborn to get out because it is stuck down with double stick foam pads.

Adicionar comentário

Remove the 4 screws (may be under the foam strips). This is the bottom of the circuit board.
  • Remove the 4 screws (may be under the foam strips). This is the bottom of the circuit board.

Adicionar comentário

Turn the board over and locate the 2 position dip switch.
  • Turn the board over and locate the 2 position dip switch.

  • This dip switch adjusts the glass breakage microphone sensitivity

  • Sensitivity settings:

  • 1 off & 2 off = high

  • 1 on & 2 off = mid (factory setting)

  • 1 off & 2 on = low

  • 1 on & 2 on = super low

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

3 outras pessoas concluíram este guia.

mpeeples

Member since: 04-04-2010

184 reputação

Autoria de 1 guia

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 10

Todo: 1,792