Introdução

If the display is malfunctioning on your Acer Aspire V5-122P-0468 laptop follow this guide to replace it yourself.

  1. Remove the nine 4mm screws with a PH0 screwdriver.
    • Remove the nine 4mm screws with a PH0 screwdriver.

    • Remove the two 6mm screws with a PH0 screwdriver.

    Adicionar comentário

  2. Remove the black rubber tab on the back of the computer
    • Remove the black rubber tab on the back of the computer

    • Remove the 4mm screw hidden underneath the black tab with a PH0 screwdriver.

    Adicionar comentário

    • Orient the computer upside down, with the hinges facing away from you.

    • Find the black plastic piece in the SD card slot on the right side of the computer.

    • Remove the plastic piece by sliding it out of the SD card slot.

    Adicionar comentário

    • Insert a spudger at these eight locations to disengage the plastic tabs from the housing cover, and pry apart.

      • Continue around the entire perimeter of the cover with the spudger.

    • Use a spudger to pry the cover around I/O ports.

    Adicionar comentário

    • Remove the two 4mm screws using a PH0 screwdriver.

    • Depress the tabs holding the battery with a spudger.

    • Disconnect the battery connector from the motherboard using a spudger.

    • Pull the battery up and away from the laptop to remove.

    Adicionar comentário

    • Flip up the black locking tab on the ZIF connector, and pull out the ribbon cable.

    Adicionar comentário

    • Wedge a spudger in between the plastic bezel frame and back cover to create a gap.

    • Then insert a plastic opening tool to pry apart the bezel from the back cover.

    • Work your way around the perimeter of the cover with the plastic opening tool.

    Adicionar comentário

    • Open up the laptop to unsnap the hinges from the back of the computer.

    • Slide the pin connector and cable through the hinge that connects the display to the rest of the laptop.

    Adicionar comentário

    • Remove the transparent tape covering the pin connector.

    • Unplug the pin connector from the display.

    Adicionar comentário

    • Cut the tape between the display and the plastic frame using the flat end of a spudger.

    • Work the spudger around the perimeter of the display to separate it from the bezel.

    • The display is attached with a strong adhesive. Applying heat with a hairdryer or heat gun may make the removal process easier.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Nat McCormick

Member since: 15-02-2018

645 reputação

5 Guides authored

Equipe

USF Tampa, Team S16-G1, Boczar Spring 2018 Membro de USF Tampa, Team S16-G1, Boczar Spring 2018

USFT-BOCZAR-S18S16G1

5 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 6

Todo: 84