Introdução

Replacing a bad power supply board will ensure that your monitor gets power.

Lay the monitor on a flat surface so that the back is facing up.
  • Lay the monitor on a flat surface so that the back is facing up.

Adicionar comentário

Grab the hinge cover with both hands on either side of the stand.
  • Grab the hinge cover with both hands on either side of the stand.

  • Squeeze inwards with your thumbs and fingers and lift up to remove the hinge cover.

Adicionar comentário

  • Remove the four 12.1 mm Phillips #2 screws that hold the stand to the monitor.

  • Support the monitor while removing the screws to prevent the monitor from falling.

  • Lift up to detach the stand.

Adicionar comentário

  • Remove the five 9.5 mm Phillips #2 screws located around the perimeter of the monitor.

Adicionar comentário

  • Starting at the corner of the monitor, wedge the small plastic opening tool between the back cover and the display bezel.

  • Tilt the plastic opening tool up to separate the back cover from the display bezel.

  • Continue around the perimeter of the monitor until the display bezel comes off.

  • A reasonable amount of force is necessary to detach the back cover from the display bezel.

Adicionar comentário

  • Reposition the monitor so that the back is facing up.

  • Grab the corners of the monitor and jiggle them upwards to detach the back cover from the inside of the monitor.

  • Lift the back cover up.

Adicionar comentário

  • Remove the two 5.7 mm Phillips #2 screws located on either side of the EMI shield.

Adicionar comentário

  • Using a nut driver (or if necessary, needle-nose pliers), remove the two nuts on either side of the VGA input.

Adicionar comentário

  • Grab the metal casing by the sides and slide it down towards the bottom of the monitor.

  • Lift up to remove the metal casing.

  • Beware, metal casing is sharp!

Adicionar comentário

  • Remove the three 7.5 mm Phillips #2 screws and one silver 8.3 mm Phillips #2 screw from the power supply.

Adicionar comentário

  • Remove the two pieces of yellow tape on the left side of the power supply.

Adicionar comentário

  • Remove the four little white clips located underneath the tape by lifting up on their left side.

  • It would be a good idea to take a picture of the way these connect before removing them.

Adicionar comentário

  • With the needle-nose pliers, remove the four display connectors by pulling them away from the power supply.

Adicionar comentário

  • Pull up and remove the white plug that connects the blue and brown wires to the power supply.

Adicionar comentário

  • Remove the rainbow-colored power cable by pulling it straight up.

Adicionar comentário

  • Using the needle nose pliers, pinch the white clip so that it can fit through the hole in the power supply.

  • Lift up the power supply and remove it from the rest of the monitor.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

5 outras pessoas concluíram este guia.

Keith

Member since: 06-10-2011

246 reputação

4 Guides authored

Equipe

Cal Poly, Team 20-26, Maness Fall 2011 Membro de Cal Poly, Team 20-26, Maness Fall 2011

CPSU-MANESS-F11S20G26

4 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 6

Últimos 7 dias: 31

Últimos 30 dias: 100

Todo: 10,828