Acer AL1714 LCD Replacement

Introdução

This guide will demonstrate the steps needed to disconnect and replace the LCD in the Acer AL1714. A malfunction in this part can cause possible issues with the ability to view images on your device.

O que você precisa

Passo 1 LCD

Acer AL1714 LCD Replacement, LCD: passo 1, imagem 1 %32

Acer AL1714 LCD Replacement, LCD: passo 1, imagem 2 %32

Turn the monitor facedown.
Unscrew the 5 screws holding the back cover on.
(This may require flipping the monitor over and shaking the screws loose once they're already unscrewed)

Editar

Passo 2

Acer AL1714 LCD Replacement: passo 2, imagem 3 %32

Take the edge tool or a metal ruler and insert it into the bezel.
Apply pressure and push down.
Do the same to the right side.
Once the side of the bezel facing you is decoupled, take the back cover and pry it loose.
(This will require some force, you will hear a loud popping/snapping noises)

Editar

Passo 3

Acer AL1714 LCD Replacement: passo 3, imagem 3 %32

Remove the Power Button Circuit Board Flat Flex Cable from the Power Supply board under the metal cover.
Pull the cord back and out of the way.
(It may be stuck down with adhesive)

Editar

Passo 4

Acer AL1714 LCD Replacement: passo 4, imagem 3 %32

Unscrew the cord anchors for the VGA port.
(Use needle nose pliers if they're too tight for removal by hand)

Editar

Passo 5

Turn the monitor around.
Unscrew the 1 screw holding the Flat Power Cable cover in place.
Lift up and remove the Flat Power Cable cover.
(Careful: it may be sharp)

Editar

Passo 6

Unscrew the 5 screws holding the metal cage on.

Editar

Passo 7

Turn the monitor around.
Lift up on the back of metal cage, slightly.
Pull the cage toward self.
(Must be careful to free cover of the VGA port and power supply input)

Editar

Passo 8

Acer AL1714 LCD Replacement: passo 8, imagem 3 %32

Lift up on the Flat Flex Cable holder tabs to release the cords.
Lift up on the Flat Flex Cables and bend them out of the working area.

Editar

Passo 9

Acer AL1714 LCD Replacement: passo 9, imagem 3 %32

Unplug the 4 backlight wires from their ports on the Power Supply board.
(Considering their size, the best way to unplug the backlight wires is by slowly jiggling and pulling the wires out of place)

Editar

Passo 10

Unscrew the 5 screws holding the Power Supply and Video Display boards.

Editar

Passo 11

Lift and remove the joined Power Supply and Video Display boards.

Editar

Passo 12

Acer AL1714 LCD Replacement: passo 12, imagem 3 %32

Carefully detach the Power Supply and Video Display boards at the connector joint.
(This step is not necessary to replace the LCD Module. This step is only a safety precaution so as not to bend or break the Power Supply connector joint)

Editar