Introdução

This is a guide that shows you how to replace the fan for a ASUS X552LAV-BBI5N08 laptop.

Battery is not showed in pictures.
  • Battery is not showed in pictures.

  • Flip the laptop face down.

Adicionar comentário

Slide the right button to the left. Hold the left button to the right. While you hold the left button in position, slide the battery out by pushing it away from you.
  • Slide the right button to the left.

  • Hold the left button to the right.

  • While you hold the left button in position, slide the battery out by pushing it away from you.

Adicionar comentário

Locate the bottom panel. It is at the opposite end of the battery.
  • Locate the bottom panel. It is at the opposite end of the battery.

  • Remove the two 12mm screws at the bottom panel with a Tri-wing Y1 screwdriver.

Adicionar comentário

Remove bottom panel by lifting it up. Remove bottom panel by lifting it up. Remove bottom panel by lifting it up.
  • Remove bottom panel by lifting it up.

Adicionar comentário

Remove the four 5.5mm screws located on the hard drive case using a Tri-wing Y1 screwdriver. Slide the hard drive out to the left. Slide the hard drive out to the left.
  • Remove the four 5.5mm screws located on the hard drive case using a Tri-wing Y1 screwdriver.

  • Slide the hard drive out to the left.

Adicionar comentário

Use opening tool to split keyboard from base of the laptop. Make sure to start from one end and go around the edges. Use Tri-wing Y1 screwdriver to remove two 12mm screws from battery area.
  • Use opening tool to split keyboard from base of the laptop.

  • Make sure to start from one end and go around the edges.

  • Use Tri-wing Y1 screwdriver to remove two 12mm screws from battery area.

Adicionar comentário

Flip laptop to sit on its bottom. Lift keyboard up by the front edge Lift keyboard up by the front edge
  • Flip laptop to sit on its bottom.

  • Lift keyboard up by the front edge

Adicionar comentário

Flip up the small locking flap for the two ZIF connectors. Unplug connectors that are keeping keyboard connected Unplug connectors that are keeping keyboard connected
  • Flip up the small locking flap for the two ZIF connectors.

  • Unplug connectors that are keeping keyboard connected

Adicionar comentário

Flip up the locking flap for the ZIF connector. Unplug the connector that is keeping the keyboard connected. Unplug the connector that is keeping the keyboard connected.
  • Flip up the locking flap for the ZIF connector.

  • Unplug the connector that is keeping the keyboard connected.

Adicionar comentário

Remove keyboard from laptop. Remove the five 4mm screws (with a Tri-wing Y1 screwdriver) that are both connecting the fan and motherboard. Pull out WiFi from below the cooling fan by lifting the edge nearest to the fan and sliding it towards the fan.
  • Remove keyboard from laptop.

  • Remove the five 4mm screws (with a Tri-wing Y1 screwdriver) that are both connecting the fan and motherboard.

  • Pull out WiFi from below the cooling fan by lifting the edge nearest to the fan and sliding it towards the fan.

Adicionar comentário

Lift yellow ZIF connector from the top of the motherboard to remove the connector. Lift up motherboard from bottom edge towards the screen. Lift up motherboard from bottom edge towards the screen.
  • Lift yellow ZIF connector from the top of the motherboard to remove the connector.

  • Lift up motherboard from bottom edge towards the screen.

Adicionar comentário

Unplug the two bundled cable connector from pin sockets below the fan. Remove the motherboard and place on a flat surface.
  • Unplug the two bundled cable connector from pin sockets below the fan.

  • Remove the motherboard and place on a flat surface.

  • Remove four 4mm screws with a Tri-wing Y1 screwdriver from the CPU.

Adicionar comentário

Disconnect bundled cable connector from the motherboard Remove fan part from the motherboard.
  • Disconnect bundled cable connector from the motherboard

  • Remove fan part from the motherboard.

Adicionar comentário

Remove the black tape from the top of the fan radiator. Remove radiator by tilting it down and pulling it out from the fan. Remove radiator by tilting it down and pulling it out from the fan.
  • Remove the black tape from the top of the fan radiator.

  • Remove radiator by tilting it down and pulling it out from the fan.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Jason Vo

Member since: 15-02-2018

857 reputação

5 Guides authored

Equipe

USF Tampa, Team S17-G1, Boczar Spring 2018 Membro de USF Tampa, Team S17-G1, Boczar Spring 2018

USFT-BOCZAR-S18S17G1

4 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 6

Todo: 30