ASUS Q324UA-BHI7T17 Power chip Replacement

Escrito Por: Scott Santiago (e outro colaborador)

Comentários: 0
Favoritos: 1

ASUS Q324UA-BHI7T17 Power chip Replacement

Dificuldade

Moderado

Passos

Tempo necessário

10 - 15 minutos

Introdução

Sometimes a laptop will not turn on due to a fried power chip. That means no information will be sent to the motherboard to turn on the laptop, however the power chip is also associated with the volume keys, therefore maybe it will turn on but the volume controls on the side will not work. If either of these things happen, follow this guide to replace the faulty power chip.

Ferramentas

Comprar estas ferramentas

Peças

57Wh OEM Genuine C31N1538 Laptop Battery

Não está à venda

Visualizar
ASUS Q324UA-BHI7T17 Power chip

Não está à venda

Visualizar

Passo 1 Battery

Remove all 10 crews on the backplate using a Phillips #00 Screwdriver.

Remove all 10 crews on the backplate using a Phillips #00 Screwdriver.
All 10 screws are 0.55 inches and 20 mm in diameter.

Editar

Passo 2

Carefully remove the backplate using the plastic opening tool.

Carefully remove the backplate using the plastic opening tool.

Editar

Passo 3

Locate the battery near the bottom.

Editar

Passo 4

Next, unplug the battery from the laptop in the upper left side of the battery, using tweezers.

Next, unplug the battery from the laptop in the upper left side of the battery, using tweezers.
Make sure to complete this step with caution, because if the battery is not unplugged, the motherboard may shock you.

Editar

Passo 5

Remove the six screws holding in the battery with a Phillips #0 screwdriver.

Once battery is lifted out and removed, proper dispose of the old battery.

Remove the six screws holding in the battery with a Phillips #0 screwdriver.
Once battery is lifted out and removed, proper dispose of the old battery.
Each screw is 0.5 cm in length and 0.5 cm in diameter.

Editar

Passo 6 Power chip

Remove the screw holding the Power chip in place and remove it using a Phillips head #0 screw driver.

Remove the screw holding the Power chip in place and remove it using a Phillips head #0 screw driver.
Screw length is 0.5 cm in length and 0.5 cm in diameter

Editar

Passo 7

Locate the ribbon connector connecting the power chip to the mother board.

Simply lift up the black component and the ribbon connector should be released, then the power chip should pop out easily.

Locate the ribbon connector connecting the power chip to the mother board.
Simply lift up the black component and the ribbon connector should be released, then the power chip should pop out easily.
Discard of the old power chip properly.