Conserte seus objetos Comunidade Loja

3DR Solo Leg Replacement

Introdução

This guide shows how to remove the legs on the bottom of the drone.

O que você precisa

  1. 3DR Solo Leg Replacement, Propeller: passo 1, imagem 1 %32

    • Grip the arm, which is located underneath the propeller, with one hand, and with your dominant hand grip the center of the propeller.

    Editar

  2. 3DR Solo Leg Replacement: passo 2, imagem 1 %32

    • Twist the propeller from the locked to unlocked position as indicated by the images of the lock.

    • You will need to twist in this direction for 2-3 full rotations before the propeller will detach.

    Editar

  3. 3DR Solo Leg Replacement: passo 3, imagem 1 %32

    • Lift the propeller off the motor.

    • To remove the silver-top propellers, repeat these steps, turning the propellers in the opposite direction of the black-top propellers.

    Editar

  4. 3DR Solo Leg Replacement, Leg: passo 4, imagem 1 %32

    • Place the controller on a flat surface with the battery side down.

    Editar

  6. 3DR Solo Leg Replacement: passo 5, imagem 1 %32 3DR Solo Leg Replacement: passo 5, imagem 2 %32 3DR Solo Leg Replacement: passo 5, imagem 3 %32

    • Locate the leg and remove the two 10mm screws that hold the leg in place.

    Editar

  7. 3DR Solo Leg Replacement: passo 6, imagem 1 %32

    • Gently pull the leg up to remove it from its position.

    • Leg should be connected by a black wire.

    Editar

  8. 3DR Solo Leg Replacement: passo 7, imagem 1 %32 3DR Solo Leg Replacement: passo 7, imagem 2 %32 3DR Solo Leg Replacement: passo 7, imagem 3 %32

    • Locate the rubber grip at the end of the leg and, with your thumb, peel it back and pull it off.

    Editar

  9. 3DR Solo Leg Replacement: passo 8, imagem 1 %32 3DR Solo Leg Replacement: passo 8, imagem 2 %32

    • Leg type 1 will contain a 1mm screw at the base of the leg.

    • Unscrew the 1mm screw located at the end of the leg.

    Editar

  10. 3DR Solo Leg Replacement: passo 9, imagem 1 %32

    • Gently pull the black cord up to release it from the leg.

    Editar

  11. 3DR Solo Leg Replacement: passo 10, imagem 1 %32 3DR Solo Leg Replacement: passo 10, imagem 2 %32 3DR Solo Leg Replacement: passo 10, imagem 3 %32

    • Leg type 2 will contain the antenna wire.

    • Gently pull up on and remove the plastic covering labeled "solo antenna".

    • Locate the antenna wire and carefully pull up and remove it.

    • The antenna wire is flimsy so use caution upon removal.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

com 3 outros contribuidores

Leia Harlow

Membro desde: 09/11/17

101 Reputação

Autoria de 1 guia

Emblemas: 4

+1 outro emblema

Equipe

CSU Fullerton, Team S2-G3, Bruce Fall 2017 Membro de CSU Fullerton, Team S2-G3, Bruce Fall 2017

CSUF-BRUCE-F17S2G3

Membros da 4

Autoria de 5 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 3

Duração total: 324