Introdução

Replacing burnt out or broken bulbs is a quick and easy fix that makes your car easier to see from behind, helping to prevent accidents.

  1. Locate the plastic casing that holds the trunk liner in place, directly behind the tail light.
    • Locate the plastic casing that holds the trunk liner in place, directly behind the tail light.

    • Unscrew the plastic casings.

    Adicionar comentário

  2. Make sure to put some pressure on the tail light itself so it does not fall out when you unscrew it.
    • Make sure to put some pressure on the tail light itself so it does not fall out when you unscrew it.

    • Unscrew the three plastic wing nuts located behind the tail lights.

    Adicionar comentário

    • When the tail light assembly comes loose, do not fully remove it because it may damage the connected wires.

    • Carefully pull the tail light away from the car to expose the connected wires.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Unclip the rear panel of the tail light assembly. There are two clips on the top and two on the bottom.

    • Remove the rear panel from the rest of the assembly.

    Adicionar comentário

    • Do not pull on the bulb, handle it gently because it is fragile.

    • Grab the plastic base of the bulb and gently wiggle it free.

    Adicionar comentário

    • When handling the new bulbs, avoid touching the glass as much as possible because this can reduce the life of the bulb.

    • Gently push the new bulb into the plastic housing.

    Adicionar comentário

    • After putting the new bulbs in, turn the desired lights on to check that the newly installed bulbs work correctly.

    • These bulbs have different functions including blinkers, brake lights, hazard lights, and back-up lights. They will only turn on when the necessary signal is sent.

    My reverse lights work my turning signal works and my brake lights work but what's up with my dimmer lights you know when you're driving at night you have the dimmer lights and then you press the brake lights and the brake lights come on

    Richard Santana - Responder

Conclusão

To reassemble your device, follow these instructions in reverse order.

4 outras pessoas concluíram este guia.

Sank Yang

Member since: 03-10-2012

345 reputação

5 Guides authored

Equipe

Cal Poly, Team 9-15, Amido Fall 2012 Membro de Cal Poly, Team 9-15, Amido Fall 2012

CPSU-AMIDO-F12S9G15

4 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 4

Últimos 7 dias: 22

Últimos 30 dias: 137

Todo: 14,003