Conserte seus objetos Comunidade Loja

1992-1999 BMW 3 Series Driver Side Airbag Replacement

Introdução

Use this guide to replace the driver side airbag in your BMW E36. This procedure was done on a US 1997 M3 with the four spoke steering wheel.

O que você precisa

    • This step is not necessary, but it made it easier for me to get at the steering column trim mounting screw. Feel free to skip this if you'd like.

    • Remove the two screws securing the upper edge of the knee bolster.

    • Pull the upper edge down to give access to the underside of the steering wheel.

    Editar

    • Remove the lower steering column trim mounting screw.

    • Remove the lower steering column trim.

    Editar

    • Make sure that the battery has been disconnected for at least 30 minutes before continuing further to ensure that the airbag light does not come on.

    • Disconnect the orange SRS connector.

    Editar

    • Completely loosen the two T30 Torx screws behind the steering wheel while supporting the airbag unit from the front.

    • Make sure to support the airbag to prevent it from falling out.

    Editar

    • Lift the airbag unit up and away from the steering wheel.

    • Disconnect the orange harness connector from the rear of the airbag unit.

    • The airbag should now be free to be removed.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

com 1 outro contribuidor

Geoff Wacker

Membro desde: 09/30/13

89.956 Reputação

Autoria de 89 guias

Emblemas: 44

+41 outros emblemas

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 15

Duração total: 550