Ir para o conteúdo principal

Repair information and guides for the CDMA version of the fourth generation iPhone. Model: A1349 / 8, 16, or 32 GB storage capacity

295 Perguntas Visualizar todos

Logic Board Rubber Bumper Location?

I replaced the display assembly this weekend, but when I was attempting to reinstall the logic board (step 21 of the guide, in reverse), a small rubber bumper came loose from 'somewhere' on the board (I think).

Here's a picture of the bumper (with the broken screen as a backdrop to give you a sense of proportion). Can somebody identify where it belongs? It's seldom good when you've got parts left over!

Block Image

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação 3
Adicionar um comentário

4 respostas

Solução escolhida

It goes on top of the Logic Board, under the two Front Screen Flex Cables. I have seen a couple of iPhone 4 without this installed or just missing and they functioned perfectly.

Esta resposta foi útil?

Pontuação 8

2 comentários:

That did it!

por

That was a huge help. Thanks!

por

Adicionar um comentário

Also, notice there is a thick and thin side to the bumper, and the thin side should be on top, or toward the back panel.

Esta resposta foi útil?

Pontuação 2
Adicionar um comentário

That little plastic bumper folds over the top of the logic board assembly where the Digitizer ( Front Panel) cables come up and over. If you look close at the bumper there is a small grove that is the same size as the boards thickness. Its just there to protect the Digitizer's cables from the rough surface of the logic board.

Esta resposta foi útil?

Pontuação 2

1 comentário:

Thanks for that info... Super helpful

por

Adicionar um comentário

what would happen if you were to put this on the wrong way

Esta resposta foi útil?

Pontuação 0
Adicionar um comentário

Adicionar a sua resposta

Matt Strange será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Duração total: 7,378