How to replace an xbox 360 wireless controller 3D analog sensor
My right analog stick is messed up beyond belief so I'd much rather replace the 3d instead of buying a whole new controller. I know I have to de-solder the 3d from the back of the board, but I'm not exactly sure of all the points that need to be done, so my question is as follows:
Can someone give me a little pictorial on which points I need to un-solder and how to correctly install the new 3d?
the link for the replacement 3d: http://www.miniinthebox.com/replacement-...
I have a CG board (not CG2)
Thanks in advance
Esta é uma boa pergunta?