Ir para o conteúdo principal

Quinta Geração do Iphone. A Reparação deste dispositivo é correta, requer ferramentas especificas e paciência. GSM/CDMA/16, 32 OR 64 GB/Black or White.

2189 Perguntas Visualizar todos

small part dropped out during repair, where does it go?

Hi, I recently tried to install a new screen in my iphone and during re-assembly a small gold clip about 5mm long

dropped out, I have looked at all the 4s exploded views I can find and that part is never there. Also now flash sin't working on camera and nor is wifi, anyone got any ideas why this is so? Any help would be greatly appreciated, as I now have a £500 phone in bits on my desk. :-(

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação 3
Adicionar um comentário

4 respostas

Solução escolhida

Is it this?

Block Image

Block Image

Also, any idea on the black rubber part?

Esta resposta foi útil?

Pontuação 4

4 comentários:

Hi I can confirm the little black rubber bit sits at the top of the logic board and protects the display cable from damage. Thanks for the info but I'm not sure if that's the right part, it does look similar I'll upload a pic of it tomorrow.

por

Hello again look thanks man that IS the part, not sure if it will fix problem with the flash but i hope it does, TOP MAN!

por

thank you so much!!! i had this left over too :) :) :)

por

Adicionar um comentário

it's probably the where the camera mounts. without pictures, i can't know for sure. i recommend following the guide to replace the lcd screen for the phone. it'll show step by step instructions and you'll eventually come across that part in the walk-through.

Update

iPhone 4S Screen Replacement

Step 16, enlarge the picture where the person has the camera in his finger tips. Look where the camera was and you'll notice the piece you're missing. It's normally underneath the black sticker on your logic board where the camera sits. The location of the black rubber piece is a problem I've been having also. I'm almost certain it was on the logic board by the display ribbon connector, the top edge, but i'm not certain. I'll let you know if I figure it out. Please do the same if you find out.

Update

Step 23 also shows the gold clip as well. That screw he takes out holds that gold clip in.

Update

Step 25 also shows a very clear picture. Enlarge the picture to the max and you'll see it at the bottom right.

Update

lol, step 26 pretty much sums up everything...

Esta resposta foi útil?

Pontuação 2
Adicionar um comentário

Yes the gold piece is the camera ground clip and is held in place with a screw on the upper left of the circuit board. The black piece is a protector that is on the upper left/top of the circuit board for the Screen connection ribbons to bend over and connect to the circuit board.

Esta resposta foi útil?

Pontuação 2
Adicionar um comentário

The gold piece is the camera ground. It belongs under the motherboard corner screw closest to the camera. The "prongs" should be against the top of the case and the screw covered with the black "tape". Hope this helps.

Esta resposta foi útil?

Pontuação 0
Adicionar um comentário

Adicionar a sua resposta

Oscar será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 4

Duração total: 37,606