Opções

Black screen after replacing flex cable. [SOLVED]

[THE PROBLEM]

I ran into an issue in the shop where after replacing the Flex cable every screen I tried was black. The iPod wouldn't even beep when plugged in.

Since I googled the tar for a solution, and couldn,' find one, I'll post what I found for anyone else with the same problem who hasn't been able to find a solution.

The solution is moved below, to the answer so that it can be cleared per request.

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação 2

2 comentários

Please use the last paragraph as an answer and accept it to clear the question.

15 de mar de 2012 por rj713

Thanks for letting me know guys, I did as you suggested.

19 de mar de 2012 por Country Computer Service

Adicionar um comentário

Postado: 19 de mar de 2012

Opções

[HOW TO FIX IT]

I covered the circuits around the flex cable and de-solder it then cleaned up the pads and soldered on the new flex.

Not adhering to my own soldering instructions, of course I got in a rush and did this without de-soldering the + terminal on the battery first.

In my case, I went back and disconnected the + terminal on the battery and soldered it back on. The black screen went away and the iPod kicks up just fine.

I hope this helps fellow techs that may have found this.

Esta resposta foi útil?

Sim Não

Pontuação 3

Adicionar um comentário

iPod Touch 4th Generation

Black screen after replacing flex cable. [SOLVED]

1 resposta

Adicionar a sua resposta