Hello. My Imac (27-inch, Late 2012) has the original memory (2x4GB Elpida) in slots 1 and 2. When trying to install in slots 1+3, 1+4, 2+3, 2+4 it beeps three times and the Mac does not start. Replacing the original memory in slots 1+2 with new memory (2x8GB) is successful. Can not add memory to slots 3 and 4 (old memory or new). Please advise where to look for the problem.
Esta pergunta é pertinente?
Reputação: 463,8 mil
35
310
965
If you have the correct RAM, then make sure the SO-DIMM’s are properly inserted and the contacts are clean.
Esta resposta foi útil?
original memory installed in slots 1 + 2 or 1 or 2 works fine. If the original memory is installed in slots 1+3 or 1+4 or 2+3 or 2+4 or 3+4 or 3 or 4. Slots visually clean, slot 3 and 4 do not differ from 1 and 2. Maybe the problem is in slots 3 and 4 ?
@Олег Б. - Then the RAM slot is damaged.
Últimas 24 horas: 0
Últimos 7 dias: 1
Últimos 30 dias: 7
Duração total: 57
As you can see here your system can support 32GB!
But you need the correct SO-DIMMs
PC3-12800 1600 MHz DDR3L SDRAM (204-pin)
27” iMac "Core i5" 2.9GHz
27” iMac "Core i7" 3.4GHz
por Dan