How can I get this ribbon cable to connect?

Question

MacBook Pro 13" com tela Retina - Final de 2013

Modelo A1502 / processador 2,4, 2,6 ou 2,8 GHz de dois núcleos / Lançado em outubro de 2013

552 Perguntas Visualizar todos

Tom Dilli @tomdilli

Rep: 43

2

Postado: 15 de jun de 2022

Opções

How can I get this ribbon cable to connect?

I was swapping top cases on my MacBook pro when I damaged part of the keyboard connector trying to take the ribbon cable out. I tried to put the keyboard ribbon cable back into the connector in my new top case. But it just wouldn't fit. I could start to see the layers on the ribbon cable spread apart, making it harder to put back in. At that point, I stopped, not trying to make it worse.

Is there any way at this point that I can put the ribbon cable back in so that all the keys work? Or am I better off just going to a repair shop and see if they can repair it. Is it even repairable at all?

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação 0

Adicionar um comentário

1 resposta

Solução escolhida

daniel @tech_ni

Rep: 34,6 mil

10

22

44

Postado: 15 de jun de 2022

Opções

on photo 2 the bottom of the connector is a plastic tab, lift it up, put the ribbon in and close

Esta resposta foi útil?

Sim Não

Pontuação 2

5 comentários:

I thought that too, that's why the connector is slightly broken. I tried to lift it up but the plastic is so brittle that it just breaks off. By the way, all the other connectors just slide in, no tabs or anything.

15 de jun de 2022 por Tom Dilli

@Tom Dilli your lifting the wrong side thats why its breaking

15 de jun de 2022 por daniel

@Tom Dilli - It looks broken to me! Time to replace at least the latch piece if you can. Here's the needed part Keyboard Connector (30-pin)

But if you need to replace the full connector its not easy! You'll need a good soldering iron or a hot air station. Its very easy to damage the logic board lifting the copper pads.

15 de jun de 2022 por Dan

@tech_ni sorry I totally misread your reply thanks!

15 de jun de 2022 por Tom Dilli

@tech_ni this is another follow-up to that other follow-up. I just wanted to thank you so much for your great instructions, If not for you I would have just taken it to the apple store and gotten a really expensive repair. You are a life saver!!!

15 de jun de 2022 por Tom Dilli

Adicionar um comentário

I thought that too, that's why the connector is slightly broken. I tried to lift it up but the plastic is so brittle that it just breaks off. By the way, all the other connectors just slide in, no tabs or anything. — Tom Dilli
@Tom Dilli your lifting the wrong side thats why its breaking — daniel
@Tom Dilli - It looks broken to me! Time to replace at least the latch piece if you can. Here's the needed part Keyboard Connector (30-pin)

But if you need to replace the full connector its not easy! You'll need a good soldering iron or a hot air station. Its very easy to damage the logic board lifting the copper pads. — Dan
@tech_ni this is another follow-up to that other follow-up. I just wanted to thank you so much for your great instructions, If not for you I would have just taken it to the apple store and gotten a really expensive repair. You are a life saver!!! — Tom Dilli

MacBook Pro 13" com tela Retina - Final de 2013

How can I get this ribbon cable to connect?

1 resposta

Adicionar a sua resposta