Ir para o conteúdo principal

Repair guides and support for motherboards and CPUs.

163 Perguntas Visualizar todos

So kinda nervous from devolving a short from to much paste.

I went way overboard with the thermal past on the cpu last time, I took apart an old computer and it had thermal paste everywhere so I figured no big deal to use a little extra. I’ve since learned some paste are more conductive, I’ve tried to get it off my fan as much as possible. ISO on a toothbrush type situation. So every time I jumped the mobo, cpu fan would spin for a sec and stop, no post, no nothing. I got a new board, going to have another go at it but i’m building it out of the case, just on a rubber mat, there is nothing to stop that from working right, I dont need any screws in the board right? What else can I do to make sure the 8 pin dont short? Thanks for your time, cheers.

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação 0
Adicionar um comentário

1 resposta

Solução escolhida

The motherboard's manual should have the best instructions specific to it, but in general, use an antistatic mat and antistatic gloves to protect the components from electrostatic discharge. Use a pea-sized amount of thermal paste, and always use the spacers that came with the motherboard. That can help prevent a short.

Esta resposta foi útil?

Pontuação 1
Adicionar um comentário

Adicionar a sua resposta

Nicholas Pratt III será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 37