Ir para o conteúdo principal

Lançado em junho de 2012, modelo A1278. Processador Intel com Turbo Boost, até 512 MB DDR5 de RAM vídeo

1623 Perguntas Visualizar todos

Battery or hard drive? Which do I swap first?

I am thinking of doing two separate swaps - replacing the battery first and fixing issues with the time via terminal (so my new hard drive will be recognized). Then go back and swap the hard drive. Does this sound like a good idea?

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação 0
6 comentários

Hello Jean,

Yes that sounds like a good idea! Hard drive replacements were so easy back then. I got an M1 MacBook Pro and I tried upgrading the storage but I failed. The battery may be aging so that would also be a good idea. Here is a tip: Get an SSD which is much faster and will improve performance of your computer.

Happy Fixing

-Javen

@tacofixes

por

I would rather keep the original battery, especially if it holds a good charge. A lot of the clone packs fail sooner then the original Apple batteries.

por

True Nick maybe it could be an old battery

por

One from ifixit would not fail.

por

@tacofixes The one in my 2012 13" is on limited time at this point, but I'd rather hold onto it until I can find an actual Apple battery.

I don't trust most 3rd party batteries at this point. There's more that have quality issues then ones that are similar in quality and performance.

por

Exibir mais 1 comentário

Adicionar um comentário

1 resposta

Solução escolhida

First off, don’t clone MacOS - it hasn’t worked reliably since Lion introduced recovery partitions on some of the newer Macs! You want to backup the Mac and restore it from a backup after clean installing the OS.

Second, make sure you swap the HD cable - the original cables are often SATA II and they will not work right with SSDs due to that. Not all of them are bad, but enough are you are better off doing the swap to be safe. It’s one of those issues I fix in these right away as soon as I have it open, so I know it’s been addressed due to how bad a sudden failure can be. Before you install the new cable, the trick is to put electrical tape where the old cable lived before installing it.

In terms of where to cover, refer to this photo of my old 2011 13” - I did the same in my 2012 13” when I swapped cables.

Block Image

Esta resposta foi útil?

Pontuação 5
Adicionar um comentário

Adicionar a sua resposta

Jean Marie Smith será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 132