I pad will not turn on

Question

iPad 4 Wi-Fi

Fourth generation of iPad, released November 2, 2012, available in 16, 32, or 64 GB models. Model Number A1458

218 Perguntas Visualizar todos

Assem Nagi @nagiassem

Rep: 1

1

Postado: 15 de out de 2020

Opções

I pad will not turn on

I have an iPad that ran out of battery one day and hasn’t been able to charge ever since that day I pulled it out of my drawer of junk after it being in storage for four years and crossed my fingers but nothing. I’ve cleaned the lighting port connecter and have used the power adapter for my MacBook and nothing I’ve also tried to hard reset 10 times and nothing and left it charged for 2 days and nothing .Their is a very faint clicking noise when I connect the lightning cable. Any advice on what I can do to fix this issue?

PS sorry about the grammar.

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação 0

Adicionar um comentário

2 respostas

Solução escolhida

Minho @refectio

Rep: 221,4 mil

15

289

807

Postado: 17 de out de 2020

Opções

Sounds like a dead battery. You can replace it yourself by following this guide.

Esta resposta foi útil?

Sim Não

Pontuação 2

6 comentários:

I tested the amperage and it says .005and the volts said 5 is that too low

17 de out de 2020 por Assem Nagi

Do you mean with a USB Ammeter? If so, what that is telling you is that no charge is taking place. Considering the age of the device and the time spent in a drawer, you almost certainly have a bad battery. That is the first thing to try.

18 de out de 2020 por Minho

I ordered a new battery and lighting port I will change them and let you know what happens thanks for replying.

18 de out de 2020 por Assem Nagi

Hello i ordered a new battery and replaced the battery works now but im getting an error that says

[Nand] _FindFlashMediAndKeepout: 601 physical nand block ofset 1

[nand]_fetchBorrowedList881 number of borrowed blocks 16

22 de out de 2020 por Assem Nagi

Hello again so i replaced the battery and the ipad turned on but it gave a NAND error 601 and said blocks borrowed 16 at the end of it also the amps that were drawn were 1.1 and then after a day that number went down to .01 is their anything else i should try?

23 de out de 2020 por Assem Nagi

Exibir mais 1 comentário

Adicionar um comentário

I tested the amperage and it says .005and the volts said 5 is that too low — Assem Nagi
Do you mean with a USB Ammeter? If so, what that is telling you is that no charge is taking place. Considering the age of the device and the time spent in a drawer, you almost certainly have a bad battery. That is the first thing to try. — Minho
I ordered a new battery and lighting port I will change them and let you know what happens thanks for replying. — Assem Nagi
Hello i ordered a new battery and replaced the battery works now but im getting an error that says

[Nand] _FindFlashMediAndKeepout: 601 physical nand block ofset 1

[nand]_fetchBorrowedList881 number of borrowed blocks 16 — Assem Nagi
Hello again so i replaced the battery and the ipad turned on but it gave a NAND error 601 and said blocks borrowed 16 at the end of it also the amps that were drawn were 1.1 and then after a day that number went down to .01 is their anything else i should try? — Assem Nagi