Opções

2nd samsung ssd not going in to the computer all the way

I am trying to install a 2nd hard drive in my m6700 when i try to slide it in, it is not going in all the way so i can screw it down? its a ssd samsung 860 drive looks the same on the end as a reg drive I have it the right way in the caddy it just is not going in? What am I missing

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação 1

Adicionar um comentário

Postado: 29 de ago de 2020

Opções

Size may be your problem.

Is the drive HDD (mechanical) or SSD ?

If HDD then:

2.5" hard drives normally come in one of three thicknesses:

12.5 mm - these are the Super-Phat drives that probably only larger laptops (DTRs and workstations) can fit. They usually have three platters instead of two, enabling higher capacity.
9.5 mm - this is the most common size and should fit most laptops without problems.
7 mm - these slim drives are used in thinner laptops (like ultraportables). Most SSDs are also in this size, and usually include a plastic bumper to increase the thickness to 9.5 mm in case the HDD mounting system requires it.

Esta resposta foi útil?

Sim Não

Pontuação 2

5 comentários:

I have a ssd thin and a reg mech hard drive neither would lock in. I don't know what I'm doing wrong I see inside where they lock in. I have them in the right direction. They just won't lock on so I can screw it down?

Bob

29 de ago de 2020 por Bob Cgar TV

@Bob Cgar TV

Here's the owner manual.

Go to p.17 and check if that helps you any.

29 de ago de 2020 por jayeff

@Bob Cgar TV

Did you use the rubber filler/ plastic bumper to increase the thickness to 9.5 mm ?

30 de ago de 2020 por mike

I think maybe the cage is not right I ordered a new one I tryed with 9.5 and &mm ssd neither will slide in

1 de set de 2020 por Bob Cgar TV

@Bob Cgar TV