iPad 4 digitizer has no touch after multiple replacements.

Question

iPad 4 Wi-Fi

Fourth generation of iPad, released November 2, 2012, available in 16, 32, or 64 GB models. Model Number A1458

218 Perguntas Visualizar todos

Jenny Lawson @jennyslaw

Rep: 277

The Device Dr.

5

1

Postado: 5 de abr de 2019

Opções

iPad 4 digitizer has no touch after multiple replacements.

Within the last few days, I’ve changed the digitizer on two different iPad 4’s. I changed it 4 different times and each time the touch wouldn’t work. Same issue with the second iPad 4. I am using a battery isolator. Is there a possibility by using the isolator I could have damaged any sensitive components beneath the logic board? Because it seems strange that 4 digitizers would be defective.

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação 0

1 comentário

Did you try the same digitisers on the second iPad?

5 de abr de 2019 por Roland Chandler

Adicionar um comentário

3 respostas

Solução escolhida

Minho @refectio

Rep: 221,4 mil

Refectio - Mail-in Micro-Soldering Repairs & Data Recovery

15

289

806

Postado: 5 de abr de 2019

Opções

The battery isolator should not cause any issues as there are no components underneath the connector you are isolating.

Four bad digitizers does seem far fetched…unless you are getting them from a bottom dollar vendor. It’s also possible that you accidentally damaged something on the iPad but assuming you are an experienced tech, that would be highly unlikely as well.

Ideally, you need to start from something of known-good condition, either a digi or a device to help you isolate the issue.

Esta resposta foi útil?

Sim Não

Pontuação 4

Adicionar um comentário

Ben @benjamen50 Rep: 159,7 mil Mtwo Perform 11 191 368 · Answer 1 · 2019-04-05T20:54:01-07:00

Ben @benjamen50

Rep: 159,7 mil

Mtwo Perform

11

191

368

Postado: 5 de abr de 2019

Opções

It may be something as simple as cleaning the digitizer connector on the board. Dust can get inside that connector and cause a bad connection to the replacement digitizer cable.

I use isopropyl alcohol and some gentle brushing to clean the connector.

Esta resposta foi útil?

Sim Não

Pontuação 2

Adicionar um comentário