Ir para o conteúdo principal

Lançado em 22 de setembro de 2017. Modelo A1863, A1905. Disponível com GSM ou CDMA / 64 ou 256 GB / Dourado, Prateado e Cinza Espacial.

869 Perguntas Visualizar todos

3D Touch on replacement display not working properly.

I recently replaced my iPhone 8 screen with a replacement from iFixit.

The 3D Touch function is very sensitive. Almost so its unusable, is there a solution? Is it perhaps software based?

Also it seems the refresh rate of the display is lower than the original?

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação 0
Adicionar um comentário

4 respostas

Solução escolhida

3D Touch requires individual calibration, the replacement screen will always have wrong calibration data. The only way is to keep swapping screen to find one more or less matches.

Esta resposta foi útil?

Pontuação 1

7 comentários:

You can recalibrate by resetting the phone

por

Like a factory reset and then restore from backup?

I only bought the one screen so can’t really swap around.

por

Back up your data so it isin't lost and a factory resent my not calibrate it but thy say that's the most calibrating you can do on a iPhone.

por

No it is not possible to recalibrate by using reset all settings. Connection to Apple internal DisiplayCloud and using the Horizon Machine to test pressure sensitivity is required.

por

I did a full reset and that didn't solve it.

I find it odd that iFixit wouldn't list this as a potential problem when switching screens.

por

Exibir mais 2 comentários

Adicionar um comentário

It’s most likely not a very good screen that you got. You may have to try another one if you have it, are you able to put your old one on and see if that’s any better?

Esta resposta foi útil?

Pontuação 0

1 comentário:

I could but i know 3D Touch worked on the old one since i often used it.

por

Adicionar um comentário

Go to settings/General/Accessibility/3D touch and from there you can set it to Light/Medium/firm. Your probably set to light in order to make it less sensitive set it to medium or firm.

Esta resposta foi útil?

Pontuação 0

1 comentário:

I tried the settings and that didn’t help.

por

Adicionar um comentário

Did you replace the water seal on the device? that helps with 3d touch also I believe.

Esta resposta foi útil?

Pontuação 0

1 comentário:

I did not.

However i switched back to the old display and it works fine without water seal.

por

Adicionar um comentário

Adicionar a sua resposta

Martin Carlenfors será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 2

Duração total: 412