Ir para o conteúdo principal

iPhone de quarta geração lançado em 2010. O reparo é simples, mas o vidro frontal e o LCD devem ser substituídos juntos, como uma unidade. GSM / 8, 16 ou 32 GB de capacidade / Modelo A1332 / Preto e Branco.

2375 Perguntas Visualizar todos

How to replace iPhone 4 sim card reader?

I have an iPhone 4 with the sim card reader broken. It was unlocked with a turbosim and the owner forced to extract the sim damaging one of the contacts of the sim reader.

I have the part to replace, but I´m not find a way that convinces me.

Any ideas, suggestions, thanks...

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação 0
1 comentário

I have the same problem...

can you tell me where to get the part, the sim card reader, or sim card container, whatever it is called.

and if you fixed that, pls inform me at danik_usher@yahoo.com

i would appreciate that

por

Adicionar um comentário

4 respostas

Solução escolhida

I´ve get the part from Luna Commerce (China). And I found a guy (I´m live in Argentina) that can repair iPhone logicboards. He could succesfully solder the sim card reader and the iPhone is alive again.

Esta resposta foi útil?

Pontuação 0

1 comentário:

you can get the part from united iPhone repair they are in the US and the ship really fast, the part it is only $1.85 , now the real question is who has the skills to solder those 6 pins!!!!

por

Adicionar um comentário
Pergunta mais útil

It is a very difficult job since the contacts are so small. The sim car reader is very cheap but the job is difficult. I would suggest you find a repair shop that can fix it. Surely the iPhone is worth it. I know these guys do wonders (located in UK) www.ipaqrepair.co.uk

Esta resposta foi útil?

Pontuação 2
Adicionar um comentário

Desolder the existing card reader by use of a heat gun. Then you will use a solder iron to clean up the 6 pads. I use desolder alloy to coat the pads and once the pads are dressed up I reinstall new sim card reader and using a heat gun on low heat melt the reader into place, use a little no clean flux to aid in the solder flow. Make sure to use a good 63/37 solder to anchor the 4 mounting pads. The desolder alloy is electrically conductive and has a very low melting point so you will not damage other components with to much heat, but is very brittle and needs the lead solder to make it hold better.

Esta resposta foi útil?

Pontuação 1

3 comentários:

What if 1 of the soldering pads was removed..can it be fixed ?

por

Yes, with a lot of skill, it can. In most cases, it's a real PIA to repair removed soldering pads. Sometimes, the pad can be connected using a jumper.

por

As u mentioned.a lot of skill which i don't have. Thx for ur reply

por

Adicionar um comentário

Hey I have a similar problem somone broke off the SIM card reader tray on my i phone 4 I just need to know where I can get the part asap and how much it will cost to fix it I got phone for 30$

Esta resposta foi útil?

Pontuação 0
Adicionar um comentário

Adicionar a sua resposta

Flavio será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Duração total: 13,172