Ir para o conteúdo principal

High performance tablet computer released by Apple on November 11, 2015. Model A1584.

130 Perguntas Visualizar todos

Touch Filter Replacement help

Hey Guys, I have recently done the screen replacement on the iPad Pro 12.9 1st gen and afterwards have lost all touch. I can’t seem to find any schematics or anything online. But was wondering if anyone could help me with what filter I can use to replace the existing one.

Any help would be appreciated

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação 1
Adicionar um comentário

5 respostas

Solução escolhida

Take a look at this answer Anyone got back light schematics? by our good friend @oldturkey03, this should help.

Esta resposta foi útil?

Pontuação 4

2 comentários:

Yea it’s the filter next to the 2nf cap. I’m just wondering I have a 6s board spare. Would there be the same filter on there ? Is it just a generic filter.

por

There's no such thing as a generic filter...these are ferrite beads and there are thousands of different specs. You could use the same one as the iPad Air 2, which is a 120R/450mA/0201 and see if it handles the current load properly by leaving the display at maximum brightness for a few hours.

por

Adicionar um comentário

You'll need to fill in the blanks here. You take about a filter what do you mean?

From what you are describing it sounds like your digitizer is disconnected or the ribbon cable is damaged. Review this guide iPad Pro 12.9" Screen Replacement. It’s also possible you have a bad one as well.

Esta resposta foi útil?

Pontuação 1

4 comentários:

Hey Dan. Sorry that was very vague. So after checking the logic board. There was a burnt out filter. Just above the screen flex connector on the board.

I’m just wanting to no if there’s a substitute filter I can use from another board ?

por

@petespcrepairs Take a good clear pic of the area so we can see.

por

Hey dan. IF you have a look at the link Minho just posted. You can see the filter that I’m referring too. It’s right next to the 2.0nf cap above the lcd connector.

por

@petespcrepairs - Sorry guy I don't know its value

por

Adicionar um comentário

Touch Filter MURATA BLM03AX121SN1D 120 Ohm Ferrite Bead 0402 (size)

video Filter MURATA BLM15EG121SN1D 120 Ohm 1,5A Ferrite Bead 0402 (size)

you need hot air for microsoldering ;o)

I still have enough lying around here and would send them out if necessary

Update (10.02.2021)

Mouser-Nr.: 81-GRM0335C1E2R0CA1D

specs and ordering here

https://www.mouser.de/ProductDetail/81-G...

Esta resposta foi útil?

Pontuação 0
Adicionar um comentário

What about the 2nf cap. Anyone know specs or where to get them?

Esta resposta foi útil?

Pontuação 0

1 comentário:

experience has shown that it works without the capacitor even without a jumper

check the named filters and swap them if necessary, that's all.

por

Adicionar um comentário

What do you mean by “check the named filters”

Is there a doc or specs somewhere here on this forum?

Esta resposta foi útil?

Pontuação 0
Adicionar um comentário

Adicionar a sua resposta

Peter será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 6

Últimos 30 dias: 22

Duração total: 2,276