Replaced flex cable, now power, home, touch screens not working.

Question

iPod Touch 2nd Generation

Model A1288 / 8, 16, or 32 GB capacity

451 Perguntas Visualizar todos

Stacie @stacie88452

Rep: 1

1

Postado: 9 de mai de 2011

Opções

Replaced flex cable, now power, home, touch screens not working.

I have two ipod touch gen2 (one 16gb, one 32gb). Replaced flex cable for different reasons on both, but after installation, both exhibit identical symptoms: No response to touch screen, home, or power buttons. I don't know if volume or wifi work or not, but the battery charges and both will sync with itunes. I followed instructions for flex cable install using 3M 9703 tape, per Mr. Gilks on youtube. Any suggestions on where I went wrong or what I can try next?

Responder a esta pergunta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação -1

Adicionar um comentário

2 respostas

oldturkey03 @oldturkey03 Rep: 781,7 mil 1,1 mil 893 2,3 mil · Answer 1 · 2011-05-09T15:43:55-07:00

Pergunta mais útil

oldturkey03 @oldturkey03

Rep: 781,7 mil

1,1 mil

893

2,3 mil

Postado: 9 de mai de 2011

Opções

Stacie, I am sorry I do not know Mr. Gilks. What I suggest is that you take a close look at this guide iPod Touch 2nd Generation Logic Board Replacement and double check your work. Make sure that all your connections are clean and that all connectors are seated right. Also, why did you need to replace the flex cable?

Esta resposta foi útil?

Sim Não

Pontuação 1

1 comentário:

These units had been opened by previous owners. One had a torn cable, the other had an unresponsive touch screen and I'd replaced everything but the logic board and flex cable, so I figured that was the next step. Thanks for the link, I will give it another go!

9 de mai de 2011 por Stacie

Adicionar um comentário