Battery percentage stuck at 1%

I don’t have pictures but have seen this before: there is a small component near the battery connector in the iPhone 8 that constantly gets knocked off during repair, leading to this failure.

It is an easy fix for a good microsoldering technician.

Esta resposta foi útil?

Sim Não

Pontuação 7

14 comentários:

Thanks Rany, I checked the phone in my rework lab with microscope and you are right that chip is missing and unfortunately for some reason my ZXW is not working at the moment to find out what it is, hence I was wondering if you know what the component is ?

3 de mai de 2018 por Bezad

Umm, I am sick with bronchitis, not at the lab.

Besides there is no iPhone 8 on ZXW yet IIRC.

Your best bet is to look at a good board or ask someone who has a good board to measure it for you. I think there is something stupid like a resistor on the gate line? Not sure anymore.

3 de mai de 2018 por Rany

I contacted everyone but no chance to find iP8 component schematic but finally a colleague from UK sent me the chip specification which is classified as a "ROHM Semiconductor".... I better not to mention the part no. at this stage to prevent confusion till I receive it and try it then I will share the details.

5 de mai de 2018 por Bezad

its fixed, the chip is RV3C002UN, It took me a while because couple of pads were gone too.

18 de mai de 2018 por Bezad

Bezad where you got this chip from. Looks like am stuck in same position as well

18 de mai de 2018 por Inder Singh

Exibir mais 9 comentários

Adicionar um comentário

Thanks Rany, I checked the phone in my rework lab with microscope and you are right that chip is missing and unfortunately for some reason my ZXW is not working at the moment to find out what it is, hence I was wondering if you know what the component is ? — Bezad
Umm, I am sick with bronchitis, not at the lab.

Besides there is no iPhone 8 on ZXW yet IIRC.

Your best bet is to look at a good board or ask someone who has a good board to measure it for you. I think there is something stupid like a resistor on the gate line? Not sure anymore. — Rany
I contacted everyone but no chance to find iP8 component schematic but finally a colleague from UK sent me the chip specification which is classified as a "ROHM Semiconductor".... I better not to mention the part no. at this stage to prevent confusion till I receive it and try it then I will share the details. — Bezad
its fixed, the chip is RV3C002UN, It took me a while because couple of pads were gone too. — Bezad
Bezad where you got this chip from. Looks like am stuck in same position as well — Inder Singh

Ben @benjamen50 Rep: 159,7 mil Mtwo Perform 11 191 368 · Answer 1 · 2018-05-02T06:36:24-07:00

Ben @benjamen50

Rep: 159,7 mil

Mtwo Perform

11

191

368

Postado: 2 de mai de 2018

Opções

Did you try reseating the battery cable?

It can sometimes be as simple as that as I've had a few cases where the battery ribbon cable got partially disconnected when removing the metal shield that also covers the screen cables.

Esta resposta foi útil?

Sim Não

Pontuação 3

2 comentários:

Thanks Ben for the tip, unfortunately it wasn't the the battery ribbon but a little damage to the PCB close to battery terminal which "Rany" addressed.... I am working on the logic-board and when its fixed I will share the information.

5 de mai de 2018 por Bezad

In my case this was the correct solution! The battery connection to the logic-board wasn't seating correctly. I took off the screen, the securing plate, then re-seated the battery ribbon.

11 de mai de 2023 por nshourds

Adicionar um comentário

George Blevins @georgeblevins Rep: 13 1 · Answer 2 · 2020-05-13T16:18:30-07:00

George Blevins @georgeblevins

Rep: 13

1

Postado: 13 de mai de 2020

Opções

Would love to know what the fix is for this. As my phone is stuck at 0% and in constant reboot mode. Any help greatly appreciated!

Esta resposta foi útil?

Sim Não

Pontuação 1

1 comentário:

Dobrý den, jak jste to nakonec pořešil? Mám stejný problém.

27 de out de 2021 por Tomáš Čermák

Adicionar um comentário

Ian @imac6 Rep: 1 · Answer 3 · 2018-06-28T11:00:16-07:00

Ian @imac6

Rep: 1

Postado: 28 de jun de 2018

Opções

Hey @bezad53, did you ever end up snapping a picture of where the component was on the board? I have the same issue and have ordered the component listed above - just want to verify that I'm looking in the right place.

I have a pic of the logic board if you could indicate where you did your repair. Thanks!

Pic: